LB11660FV-TLM-H ON Semiconductor

LB11660FV Monolithic Digital IC Half-pre Motor Driver Single-Phase Full-Wave, for Fan Motor www.onsemi.com Overview The LB11660FV is a single-phase bipolar drive half-predriver motor driver that can easily implement a direct PWM driver motor driver circuit with excellent efficiency. The LB11660FV is particularly well suited for the miniature fans used in servers. Features SSOP16 (225mil) Single-phase full-wave drive (15V, 1.5A transistors are built in) Half predriver with integrated high side transistor Built-in variable speed function controlled by an external input The LB11660FV can implement quiet, low-vibration variable speed control using externally clocked high side transistor direct PWM drive. Minimum speed setting pin Current limiter circuit (The limit value is determined by Rf I = 1A when RF = 0.5 ) O Built-in kickback absorption circuit Soft switching circuit makes low current consumption, low loss, and low noise drive possible at phase switching Built-in HB Built-in lock protection and automatic recovery circuits (built-in on/off ratio switching circuit controlled by the supply voltage) FG (speed detection) output Built-in thermal protection circuit (design guarantee) ORDERING INFORMATION See detailed ordering and shipping information on page 10 of this data sheet. Semiconductor Components Industries, LLC, 2015 1 Publication Order Number : August 2015 - Rev. 1 LB11660FV/D LB11660FV Specifications Absolute Maximum Ratings at Ta = 25C Parameter Symbol Conditions Ratings Unit V maximum supply voltage V max 20 V CC CC VM maximum supply voltage VMmax 20 V OUT pin maximum output I max Rf 0.39 1.5 OUT A current OUT pin output voltage 1 V max 1 20 V OUT OUT pin output voltage 2 V max 2 T 0.4 s 26.5 V OUT PRE pin maximum source IPSOmax 30 mA current PRE pin maximum sink current IPSImax 7 mA PRE pin output voltage VPmax 20 V HB maximum output current HBmax 10 mA VTH input pin voltage VTHmax 7 V FG output pin voltage VFGmax 18 V FG output current IFGmax 10 mA Allowable power dissipation Pd max When mounted on a circuit board *1 W 0.8 Operating temperature Topr *2 C 30 to +90 Storage temperature Tstg C 55 to +150 3 *1 Specified circuit board : 114.3 76.1 1.6mm , glass epoxy. *2: Tj max is 150C. This device must be used under conditions such that the chip temperature does not exceed Tj = 150C during operation. Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality should not be assumed, damage may occur and reliability may be affected. Recommended Operating Conditions at Ta = 25C Parameter Symbol Conditions Ratings Unit V supply voltage V V 4 to 15 CC CC V supply voltage VM V 3 to 15 M Current limiter operation range ILIM 0.6 to 1.2 V VTH input level voltage range VTH V 0 to 6 Hall sensor input common-mode VICM 0.2 to 3 V input voltage range Functional operation above the stresses listed in the Recommended Operating Ranges is not implied. Extended exposure to stresses beyond the Recommended Operating Ranges limits may affect device reliability. www.onsemi.com 2