NLAS7222B, NLAS7222C High-Speed USB 2.0 (480 Mbps) DPDT Switches ON Semiconductors NLAS7222B and NLAS7222C are part of a series of analog switch circuits that are produced using the companys advanced submicron CMOS technology, achieving industryleading NLAS7222B, NLAS7222C HSD1+ HSD1 HSD2 HSD1 76 76 8 5 8 5 OE D OE HSD2+ V V CC GND CC HSD2 9 CONTROL 4 9 4 CONTROL S 10 3 D+ S 10 3 GND 12 12 D+ D HSD1+ HSD2+ Figure 1. Pin Connections and Logic Diagram Figure 2. Pin Connections and Logic Diagram (NLAS7222B, Top View) (NLAS7222C, Top View) Table 1. PIN DESCRIPTION Table 2. TRUTH TABLE Pin Function HSD1+, HSD2+, OE S HSD1 HSD2 S Select Input 1 X OFF OFF OE Output Enable 0 0 ON OFF 0 1 OFF ON HSD1+, HSD1, HSD2+, Data Ports HSD2, D+, D MAXIMUM RATINGS Symbol Pins Parameter Value Unit V V Positive DC Supply Voltage 0.5 to +5.5 V CC CC V HSD1+, HSD1 Analog Signal Voltage 0.5 to V + 0.3 V IS CC HSD2+, HSD2 D+, D 0.5 to +5.5 V S, OE Control Input Voltage, Output Enable Voltage 0.5 to +5.5 V IN I V Positive DC Supply Current 50 mA CC CC T Storage Temperature 65 to +150 C S I HSD1+, HSD1 Analog Signal Continuous Current Closed Switch 300 mA IS CON HSD2+, HSD2, D+, D I HSD1+, HSD1 Analog Signal Continuous Current 10% Duty Cycle 500 mA IS PK HSD2+, HSD2, D+, D I S, OE Control Input Current, Output Enable Current 20 mA IN Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress ratings only. Functional operation above the Recommended Operating Conditions is not implied. Extended exposure to stresses above the Recommended Operating Conditions may affect device reliability. RECOMMENDED OPERATING CONDITIONS Symbol Pins Parameter Min Max Unit V Positive DC Supply Voltage 1.65 4.5 V CC V Analog Signal Voltage V HSD1+, HSD1 GND V IS CC HSD2+, HSD2 D+, D GND 4.5 V S, OE Control Input Voltage, Output Enable Voltage GND V V IN CC T Operating Temperature Range 40 +85 C A Minimum and maximum values are guaranteed through test or design across the Recommended Operating Conditions, where applicable. Typical values are listed for guidance only and are based on the particular conditions listed for section, where applicable. These conditions are valid for all values found in the characteristics tables unless otherwise specified in the test conditions.