WWW.PHIHONG.COM 19.6W Single Port Power over Ethernet Midspan IEEE802.3af Compliant Power Injector Features Compliant with IEEE802.3af Standard Limited Power Source Non-vented Case Gigabit Compatible Full Protection OVP, OCP 1 Year Warranty Applications IP Telephones Security Cameras Wireless Access Points IP Print Servers Bluetooth Access Points WiMAX Access Points Safety Approvals CE cUL/US Mechanical Characteristics Length: 140mm (5.51in.) Height: 36mm (1.42in.) Width: 65mm (2.55in.) Weight: 0.2Kg (7.58oz) Output Specifications DC Output Load Regulation Model AC Input Voltage Min. Max. Line Load POE21U-1AF Three Wire 56V 10mA 350mA 5% POE21W-1AF Two Wire 56V 10mA 350mA 5% Phihong is not responsible for any error, and reserves the right to make changes without notice. Please visit our website at www.phihong.com for the most up-to-date specifications and contact information. Revision 11/16/2011 POE21X-1AF Characteristics WWW.PHIHONG.COM INPUT: EMI AC Input Voltage Rating EN55022 Class B 100 to 240VAC FCC part 15 Class B AC Input Voltage Range EMC 90 to 264VAC ESD: IEC61000-4-2 Level 3 RS: IEC61000-4-3 Level 3 AC Input Current EFT/Burst: IEC61000-4-4 Level 2 0.8A (RMS) maximum at 120VAC Surge: IEC61000-4-5 Level 3 0.55A (RMS) maximum at 240VAC CS: IEC61000-4-6 Level3 Voltage Dips: IEC61000-4-11 Harmonic: IEC61000-3-2 Class A AC Input Frequency 47 to 63Hz Isolation (HI-POT) Primary to secondary: 1500VAC for 1 minute, 10mA Leakage Current U Model 350uA maximum W Model 250uA maximum Insulation Resistance Primary to secondary: 10M Ohm 500VDC Max In-rush Current 60A maximum at 240VAC and maximum load FEATURES: (Cold Start at ambient 25C) Cisco No extern parts required for Legacy devices: OUTPUT: VoIP Phones: 7910, 7912, 7940, 7960 Access Points: 1040, 1140, 1250, 1260, 3500 Output Power 19.6W Over Voltage/Current, Short Circuit Protection Hold up Time The output is equipped with short-circuit protection and 10mSec minimum at maximum load at 120VAC, 60Hz overload protection as per the IEEE 802.3af specification and conforms to UL60950-2. The output can be shorted permanently without damage. Transient O/P Voltage Protection 60V maximum at switch on/off at any AC line phase Indicator (Status) Solid Green: Valid IEEE802.3af load detected and Efficiency connected ON 80% Typical at maximum load at 120VAC, 60Hz Blinking Green: Power ON ready for connection Blinking Red/Green: Invalid load connected Environment Blinking Red: fault Operating Temperature 0 to +40C Non-operating Temperature -20 to +65C AC Input Connector U models - IEC320 inlet 3-pin C14 Relative Humidity 5 to 90% W models IEC320 inlet 2-pin C8 Dimension Diagram Unit: mm Output Connection +pins 3,6 / -pins 1,2 Data IN/POE OUT Connector RJ45 Warranty 1 Year Revision 11/16/2011