LCOS PANELS 5.0V 3.3V 2.5V 1.8V 1.2V DATASHEET To request the full datasheet, please visit www.intersil.com/products/isl58334 3V Wide Optical Spectrum Laser Power Monitor IC ISL58334 Features The ISL58334 photo sensor IC has a wide optical spectral High Sensitivity from 400nm to 1000nm with Patented sensitivity from 400nm to 1000nm. It is good for multiple light Technology for Improved Blue Photo Response sources application, such as laser based projectors. ISL58334 Differential Voltage Output or Single-Ended Output has two banks of three sets of gain registers. For a Pico- Projector application, the two banks of gain resistors can be Internal Output Reference or External Output Reference used to monitor bias level and peak level of each wavelength. Single +3.3V Power Supply Bank switching is done by applying a TTL compatible logic signal to HL pin. The three sets of gain registers can be used to Serial Interface for Gain Calibration adjust optical-to-electrical conversion gain for each RED, Fast Settling Time < 20ns GREEN, and BLUE laser or any wavelength in a spectral range Wide Signal Bandwidth > 80MHz for application. The ISL58334 is a single die device that has a photo detector of 0.7mm diameter in the center of the die. Wide Signal Gain Dynamic Range > 20dB Photo current signal is amplified through TIA, fine gain Low Power Consumption amplifier, and output drivers to convert from current to voltage. Low Output Offset < 50mV The output of the ISL58334 can be configured to be either differential or single-ended. Gain changing according to each Small 9-Ball Optical Chip Scale Package (OCSP) wavelength is done through 3-wire interface. Registers can be (2.2mmx2.2mm) updated in real time while the device is in operation. SPI 3-wire serial interface The ISL58334 operates from a single +3.3V supply. It is available in a space-saving 9 ball glass top BGA package. Applications Optical Power Monitoring Related Literature Laser Based Pico-Projectors or Projection TV See TB478 PCB Assembly Guidelines for Shell-Op 3D Laser Auto Power Control for laser based application Package POWER CONVERTER DIGITAL CIRCUITS ITO DRIVER VIDEO FRONT END OEIC OPTIC FEEDBACK LCOS ISL58334 AND DRIVER VIDEO PROCESSOR MCU DC/DC LASER DIODE LASER DRIVER DIODE FIGURE 1. APPLICATION BLOCK DIAGRAM April 6, 2012 CAUTION: These devices are sensitive to electrostatic discharge follow proper IC Handling Procedures. 1 1-888-INTERSIL or 1-888-468-3774 Copyright Intersil Americas Inc. 2010, 2012. All Rights Reserved FN6933.1 Intersil (and design) is a trademark owned by Intersil Corporation or one of its subsidiaries. All other trademarks mentioned are the property of their respective owners.ISL58334 For additional products, see www.intersil.com/product tree Intersil products are manufactured, assembled and tested utilizing ISO9001 quality systems as noted in the quality certifications found at www.intersil.com/design/quality Intersil products are sold by description only. Intersil Corporation reserves the right to make changes in circuit design, software and/or specifications at any time without notice. Accordingly, the reader is cautioned to verify that data sheets are current before placing orders. Information furnished by Intersil is believed to be accurate and reliable. However, no responsibility is assumed by Intersil or its subsidiaries for its use nor for any infringements of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of Intersil or its subsidiaries. For information regarding Intersil Corporation and its products, see www.intersil.com FN6933.1 2 April 6, 2012