DATA SHEET SKY77764 Power Amplifier Module for CDMA / WCDMA / HSDPA / HSUPA / HSPA+ / LTE Bands III, IV, IX (1710 MHz1785 MHz) Applications Description WCDMA handsets The SKY77764 Power Amplifier Module (PAM) is a fully matched 10-pad surface mount module developed for Wideband Code Division Multiple Access (WCDMA) applications. This small and efficient HSDPA module packs full 1710-1785 MHz bandwidth coverage into a single compact package. Because of HSUPA high efficiencies attained throughout the entire power range, the SKY77764 delivers unsurpassed HSPA+ talk-time advantages. The SKY77764 meets the stringent spectral linearity requirements of High LTE Speed Downlink Packet Access (HSDPA), High Speed Uplink Packet Access (HSUPA), and Long Term Evolution (LTE) data transmission with high power added efficiency. An integrated directional coupler CDMA2000 eliminates the need for any external coupler. EVDO The Gallium Arsenide (GaAs) Microwave Monolithic Integrated Circuit (MMIC) contains all amplifier active circuitry, including input and interstage matching circuits. The silicon CMOS support die, Features providing precision biasing for the MMIC affords a true CMOS-compatible control interface. Output match into a 50-ohm load, realized off-chip within the module package, optimizes efficiency and Low voltage positive bias supply 3.0 V to 4.5 V power performance. Good linearity The SKY77764 is manufactured with Skyworks InGaP GaAs Heterojunction Bipolar Transistor (HBT) process which provides for all positive voltage DC supply operation and maintains high efficiency and High efficiency good linearity. While primary bias to the SKY77764 can be supplied directly from any suitable battery - 46% at 28.6 dBm with an output of 3.2 V to 4.2 V, optimal performance is obtained with VCC2 sourced from a DC-DC Large dynamic range power supply adjusted within 0.5 V to 3.6 V based on target output power levels. Power down Small, low profile package executes by setting VENABLE to zero volts. No external supply side switch is needed as typicalof - 3 mm x 3 mm x 0.9 mm leakage is a few microamperes with full primary voltage supplied from the battery. - 10-pad configuration Power down control InGaP Supports low collector voltage operation Digital Enable No VREF required CMOS compatible control signals Integrated Directional Coupler FIGURE 1. SKY77764 FUNCTIONAL BLOCK DIAGRAM Skyworks Solutions, Inc. Phone 781 376-3000 Fax 781 376-3100 sales skyworksinc.com www.skyworksinc.com 201720F Skyworks Proprietary and Confidential Information. Products and product information are subject to change without notice. December 13, 2012 1 DATA SHEET SKY77764 POWER AMPLIFIER MODULE for CDMA/ WCDMA/ HSDPA/ HSUPA/ HSPA+/ LTE BANDS III/ IV/ IX (17101785) conditions are listed in Table 4. Table 3 presents a truth table for Electrical Specifications the power settings. Tables 5 through 8 provide the standard test The following tables list the electrical characteristics of the configurations for WCDMA (STC1), HSDPA (STC2), and HSUPA SKY77764 Power Amplifier. Table 1 lists the absolute maximum (STC3, STC4) respectively. ratings and Table 2 shows the recommended operating conditions. Electrical specifications for nominal operating TABLE 1. ABSOLUTE MAXIMUM OPERATING CONDITIONS No damage assuming only one parameter is set at limit at a time with all other parameters set at nominal value. Parameter Symbol Minimum Nominal Maximum Unit RF Input Power PIN 0 10 dBm 1 Supply Voltage No RF VCC1 3.8 6.0 Volts With RF 3.8 5.0 No RF VCC2 3.4 6.0 With RF 3.4 4.6 Enable Control Voltage VEN 1.8 4.2 Volts Mode Control Voltage VMODE0 1.8 4.2 Volts VMODE1 1.8 4.2 2 Case Temperature Operating TCASE 30 +25 +110 C Storage TSTG 40 +150 1 Overvoltage shutdown circuitry turns on at approximately 5 V. 2 Case Operating Temperature (TCASE) refers to the temperature of the GROUND PAD at the underside of the package. TABLE 2. RECOMMENDED OPERATING CONDITIONS Parameter Symbol Minimum Nominal Maximum Unit 1 RF Output Power WCDMA POUT MAX 28.6 dBm HSDPA 27.6 HSUPA 25.0 LTE 27.6 CDMA2000 28.0 Operating Frequency O 1710.0 1747.5 1785.0 MHz 2 Supply Voltage VCC1 3.0 3.4 4.5 Volts VCC2 0.5 3.6 Enable Control Voltage Low VEN L 0.0 0.0 0.5 Volts High VEN H 1.35 1.8 3.1 Mode Control Voltage Low VMODE0 0.0 0.0 0.5 Volts VMODE1 0.0 0.0 0.5 High VMODE0 1.35 1.8 3.1 VMODE1 1.35 1.8 3.1 3 Case Operating Temperature TCASE 20 +25 +85 C 1 For VCC < 3.4 V, output power back-off = 0.5 dB. 2 Specifications in Table 4 are specified at VCC1 = 3.2 V4.2 V. 3 Equivalent to 30 C to +75 C Ambient Operating Temperature. Skyworks Solutions, Inc. Phone 781 376-3000 Fax 781 376-3100 sales skyworksinc.com www.skyworksinc.com 2 December 13, 2012 Skyworks Proprietary and Confidential Information. Products and product information are subject to change without notice. 201720F