CPFE1000F Series Specification Model CPFE1000F-12 CPFE1000F-28 CPFE1000F-48 Input Input Voltage Range Vac 90 - 265 Input Frequency (1) Hz 47 - 63 (up to 440) (1) Input Current (110 / 220Vac) A 13.6 / 6.6 (Model dependent) Inrush Current (115 / 230Vac) A 23 / 46 peak Leakage Current mA <1.5 Power Factor - 0.95 typical (meets EN61000-3-2) Hold Up Time (Typical) at 230Vac ms 25 Efficiency (Typical, 100% load, 110 / 220Vac) % 79 / 81 83 / 86 83 / 86 Conducted & Radiated EMI - EN55032/EN55011 Class B, MIL STD 461/462D CE102 Immunity - See Immunity table Line Dip - Complies with SEMI F47 (200Vac line only) Safety Certifications and Markings - IEC/UL/CSA/EN62368-1, 60950-1, CE Mark and UKCA Mark Immunity Test Standard Test Level Criteria Notes 8 kV air discharge, ESD IEC 61000-4-2 B 4 kV contact discharge 10 V/m from 80-1000 MHz Radiated Susceptibility IEC 61000-4-3 A (80% AM at 1kHz) Power line pulses of 2kV Electrical Fast Transient Burst IEC 61000-4-4 B I/O line pulses of 1kV 4kV common mode, Surge IEC 61000-4-5 B 2kV differential mode See test report 10 Vrms, 150 kHz - 80 MHz Conducted Susceptibility IEC 61000-4-6 B 1 kHz 80% AM Inductive loop at 50 Hz, Magnetic fields IEC 61000-4-8 A to 30.0 amps (rms) per meter Voltage Dips and Input Interruptions IEC 61000-4-11 Voltage Dips of 60%, 30%, 20% and >95% Interruptions of >95%. B / C 2kV common mode surges. Oscillatory waves IEC 61000-4-12 A 1kV differential mode surges. Voltage Fluctuation EN 61000-4-14 U = 12% Un, U = +12% Un, U = -12% Un A Specification Model CPFE1000F-12 CPFE1000F-28 CPFE1000F-48 Output Line Regulation mV 48 56 96 Load Regulation mV 48 56 96 Output Voltage Setpoint Accuracy % 2 at 50% load Temperature Coefficient ppm/C 200 Ripple & Noise (20MHz BW) % 1 (2 below 0C) Minimum Load A None Overcurrent Protection % 105 - 140 (Automatic recovery) Overvoltage Protection % 125 - 145 (Automatic recovery) Overtemperature Protection C Unit shuts down between 90 - 115 (Automatic recovery) Remote Sense - Yes, Compensates up to 500mV cable drop Remote On/Off (Opto Isolated) - High = ON Power On Signal (ENA) - Open Collector (10mA sink current). Low (on) when output present Auxiliary Supply - 10 - 14V, 20mA Parallel Operation - Yes, single wire Series Operation - Possible, see installation manual 2 CPFE1000F Series