TCS10DPU(TE85L,F) Toshiba

TCS10DPU TOSHIBA CMOS Digital Integrated Circuit Silicon Monolithic TCS10DPU Digital Output Magnetic Sensor Feature Push-Pull Output South-Pole or North-Pole Detection UFV Weight: 7.0 mg (typ.) Marking Pin Assignment (top view) Function Table V (Note 1) GND2 (Note 2) CC Magnetic Flux Output Density 5 4 B L ON PA3 B H OFF 12 3 NC V OUT GND1 (Note 2) Note 1: A 0.47F capacitor should be connected near the device. This condition will not guarantee successful operation. Check the performance thorough evaluation using the actual application to set the condition. Note 2: The GND1 and GND2 pins should be tied to ground. The GND2 pin is used as a test pin during production. Start of commercial production 2008-09 1 2014-03-01 TCS10DPU Absolute Maximum Ratings (Ta = 25C) Characteristics Symbol Rating Unit Supply Voltage V 0.5 to 6.0 V CC Output Voltage V 0.5 to 6.0 V OUT Output Diode Current I 10 mA OK Output Current I 5 mA OUT Vcc/GND Current I 10 mA CC Power Dissipation P 200 mW D Storage Temperature Range T 65 to 150 C stg Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings and the operating ranges. Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook (Handling Precautions/Derating Concept and Methods) and individual reliability data (i.e. reliability test report and estimated failure rate, etc). Operating Range Characteristics Symbol Rating Unit Supply Voltage V 2.3 to 3.6 V CC Output Voltage V 0 to V V OUT CC Output Current I / I 1.0 mA OH OL Operating Temperature T 40 to 85 C opr 2 2014-03-01