TLP2310 Toshiba

TLP2310 Photocouplers GaAAs Infrared LED & Photo IC TLP2310TLP2310TLP2310TLP2310 1. 1. ApplicationsApplications 1. 1. ApplicationsApplications Programmable Logic Controllers (PLCs) Battery Management System (BMS) Transistor Inverters 2. 2. 2. 2. GeneralGeneralGeneralGeneral The TLP2310 is a 5-Mbps low-power photocoupler in the small SO6 package. The TLP2310 consumes supply current (I /I ) of only 0.3 mA maximum over the entire operating DDL DDH temperature range of -40 to 125 and operates at a supply voltage as low as 2.7 V, contributing to a reduction in power consumption of various systems. The input forward current can be less than 1 mA maximum, allowing direct drive by a microcontroller. The detector has a totem-pole output stage with current sourcing and sinking capabilities. The TLP2310 has an internal Faraday shield that provides a guaranteed common-mode transient immunity of 25 kV/s. 3. 3. FeaturesFeatures 3. 3. FeaturesFeatures (1) Package: SO6 (2) Data transfer rate: 5 MBd (typ.) (NRZ) (3) Supply current: 0.3 mA (max) (4) Threshold input current: 1.0 mA (max) (5) Supply voltage: 2.7 to 5.5 V (6) Operating temperature: -40 to 125 (7) Propagation delay time: t /t = 250 ns (max) pHL pLH (8) Pulse width distortion: t - t = 30 ns (max) pHL pLH (9) Isolation voltage: 3750 Vrms (min) (10) Safety standards UL-approved UL1577 File No.E67349 cUL-approved CSA Component Acceptance Service No.5A File No.E67349 (Note) VDE-approved: Option (V4) EN60747-5-5 (approval pending) (Note)(Note)(Note) Option (V4) Note: When an EN60747-5-5 approved type is needed, please designate the Option (V4)Option (V4)Option (V4). 4. 4. 4. 4. Packaging and Pin AssignmentPackaging and Pin AssignmentPackaging and Pin AssignmentPackaging and Pin Assignment 1: Anode 3: Cathode 4: GND 5: V (Output) O 6: V DD 11-4L1S Start of commercial production 2015-04 2015-02-09 1 Rev.1.0TLP2310 5. 5. 5. 5. Internal Circuit (Note)Internal Circuit (Note)Internal Circuit (Note)Internal Circuit (Note) Note: A 0.1-F bypass capacitor must be connected between pin 6 and pin 4. 6. 6. 6. 6. Principle of OperationPrinciple of OperationPrinciple of OperationPrinciple of Operation 6.1. 6.1. 6.1. 6.1. Truth TableTruth TableTruth TableTruth Table Input LED Output H ON H L OFF L 6.2. 6.2. 6.2. 6.2. Mechanical ParametersMechanical ParametersMechanical ParametersMechanical Parameters Characteristics Dimension(Min) Unit Creepage distances 5.0 mm Clearance distances 5.0 Internal isolation thickness 0.4 2015-02-09 2 Rev.1.0