Embedded Power for Business-Critical Continuity Rev. 03.30.10 29 LPS100-M Series 1 of 3 LPS100-M Series 150 Watts Total Power: 80 - 150 Watts Input Voltage: 90 - 264 Vac of Outputs: Single Electrical Specifications Special Features Input Medical and ITE safeties Active power factor correction Input ra nge: 90 - 264 Vac 120 - 300 Vdc 2 x 4 footprint Frequency: 47-63 Hz Less than 1U high Inrush current: 50 A max., cold start 25 C EN61000-3-2 compliant Efficiency: 88% typical at full load Remote sense EMI/RFI: Power fail FCC Class B conducted CISPR22 Class B conducted Adjustable main output EN55022 Class B conducted VDE0878PT3 Class B conducted Built-in Class B EMI filter Safety ground 275 A 50/60 Hz, 264 Vac input Overvoltage protection leakage current: Overload protection Output Thermal overload protection 100 W for convection (80 W for LPS102-M) Isolated12 V Fan output Maximum power: 150 W with 30 CFM forced air (120 W for LPS102-M) LPX50 Enclosure kit available Adjustment range: 10% minimum on the main outputs Fan output: 12 V 1 A isolated, 10% Hold-up time: 10 ms 150 W load, 120 Vac input Overload protection: Short circuit protection on all outputs. Case overload protected 110-160% above rating Overvoltage protection: 15-35% above nominal output Logical Control Power failure: Open collector logic signal goes high 100-500 msec after main output it goes low at least 6 msec before loss of regulation Remote sense: Compensates for 0.5 V lead drop min. Will operate without remote sense Safety connected. Reverse connection protected. TUV 60950, 60601-1 UL 60950, 60601-1 cULus 60950, 60601-1 CB Certificate & report CE Mark (LVD) CQC MarkEmbedded Power for Business-Critical Continuity Rev. 03.30.10 29 LPS100-M Series Environmental Specifications 2 of 3 Operating temperature: 0 to 50 C ambient derate each output as 2.5% per degree from 50 to 70 C. -20 C start up Storage temperature: -40 C to +85 C Electromagnetic Designed to meet EN61000-4 susceptibility: -2, -3, -4, -5, -6, -8, -11 Level 3 Humidity: Operating non-condensing 10% to 95% RH Vibration: IEC68-2-6 to the levels of IEC721-3-2 MTBF calculated: 534,000 hours at full load and 25 C ambient conditions, 230 V input, Bellcore Mechanical Drawing VR1 Output Voltage Adjust Pot SK203 M1 M2 1 4 SK2 8 GND 1 4 SK5 1 SK1 1 3 3.73 Mounting Hole (94.7) 0.16 4.0 4 Places 4.00 Max. Screw Head (101.6) Diameter .22 (5.6) 0.197 (5.0) Minimum Standoff height 2.00 (50.8) 1.72 (43.8) 1.29 (33.0) 0.10 (2.5)