CY7C68003 MoBL-USB TX2UL USB 2.0 ULPI Transceiver MoBL-USB TX2UL USB 2.0 ULPI Transceiver UART pass through mode Features ESD compliance: The Cypress MoBL-USB TX2UL is a low voltage high speed JESD22-A114D 8 kV Contact human body model (HBM) for (HS) USB 2.0 UTMI+ Low Pin Interface (ULPI) Transceiver. The DP, DM, and V pins SS TX2UL is specifically designed for mobile handset applications IEC61000 - 4-2 8 kV contact discharge by offering tiny package options and low power consumption. IEC61000 - 4-2 15 kV air discharge USB 2.0 Full Speed and High Speed compliant transceiver Support for industrial temperature range: (-40 C to 85 C) Multi range (1.8 V to 3.3 V) I/O voltages Low power consumption for mobile applications: Fully compliant ULPI link interface 5 A nominal sleep mode 30 mA nominal active HS transfer 8-bit SDR ULPI data path Small package for mobile applications: UTMI+ level 0 support 2.14 x 1.76 mm 20-pin WLCSP 0.4 mm pitch Support USB device mode only 4 x 4 mm 24-pin QFN Integrated oscillator Applications Integrated phase locked loop (PLL) 13, 19.2, 24, or 26 MHz Mobile phones reference PDAs Integrated USB pull-up and termination resistors Portable media players (PMPs) 3.0 V to 5.775 V VBATT input DTV applications Chip select pin Portable GPS units Single ended device RESET input TX2UL Block Diagram TX2UL ULPI Block CLOCK I/O Operational DATA 7:0 Control/ mode Tx/Rx DP Data tracking Core DIR USB Logic interrupt UTMI+ STP FS/HS Level0 Registers PHY NXT DM Block ULPI Wrapper RXD TXD Global Control Block RESET N Reset / Clock / Power / 3.3 V CS N Misc. Control Regulator VBATT (3.0 Block 5.775 V) VCC POR (1.8 V) 1.8 V Bandgap XI PLL 13/19.2/ XOSC XO 24/26 MHz Cypress Semiconductor Corporation 198 Champion Court San Jose, CA 95134-1709 408-943-2600 Document Number: 001-15775 Rev. *O Revised May 30, 2017CY7C68003 Contents Functional Overview ........................................................3 Configuration Mode ........................................................ 16 UTMI+ Low Pin Interface (ULPI) .................................3 Configuration Mode in 20-Pin CSP package ............. 16 Oscillator (OSC) ..........................................................3 Configuration Mode in 24-Pin QFN package ............. 16 Phase Locked Loop (PLL) ...........................................3 Power On Reset (POR) ............................................. 16 Power On Reset (POR) ...............................................3 Register .....................................................................16 Reset (RESET N) .......................................................3 Register Map ............................................................. 16 DP and DM pins ..........................................................3 Immediate Register Set ............................................. 17 Chip Select (CS N) .....................................................3 Function Control Register .......................................... 17 USB2 Transceiver Macrocell Interface (UTMI+) ..........3 Interface Control Register ......................................... 18 Global Control .............................................................3 Debug Register ......................................................... 18 Full Speed Scratch Register ........................................................ 18 and High Speed USB Transceivers (FS/HS) ......................3 Carkit Control Register .............................................. 18 USB Pull up and Intr Detect, Drive Strength Termination Resistors (Pull up/TERM) ...............................3 and Slew Rate Configuration Register ............................. 19 UART Pass Through Mode .........................................3 USB Interface Control Register ................................. 19 Clocking .......................................................................4 Absolute Maximum Ratings .......................................... 20 Power Domains ...........................................................4 Operating Conditions ..................................................... 20 Operation Modes .........................................................5 DC Characteristics ......................................................... 21 VID and PID ................................................................6 AC Characteristics ......................................................... 21 Pinouts ..............................................................................7 Ordering Information ...................................................... 24 Synchronous Operation Modes ......................................9 Ordering Code Definitions ......................................... 24 ULPI Transmit Command Byte (TX CMD) ..................9 Package Diagrams .......................................................... 25 ULPI Receive Command Byte (RX CMD) ...................9 Acronyms ........................................................................27 USB Data Transmit (NOPID) .....................................10 Document Conventions ................................................. 27 USB Data Transmit (PID) ..........................................11 Document History Page ................................................. 28 USB Packet Receive .................................................11 Sales, Solutions, and Legal Information ...................... 30 Immediate Register Read and Write .........................12 Worldwide Sales and Design Support ....................... 30 Immediate Register Read and Write Products ....................................................................30 Aborted by USB Receive ..................................................13 PSoC Solutions ...................................................... 30 Back to Back Immediate Register Read and Write Cypress Developer Community ................................. 30 and USB Receive .............................................................14 Technical Support ..................................................... 30 Document Number: 001-15775 Rev. *O Page 2 of 30