Please note that Cypress is an Infineon Technologies Company. The document following this cover page is marked as Cypress document as this is the company that originally developed the product. Please note that Infineon will continue to offer the product to new and existing customers as part of the Infineon product portfolio. Continuity of document content The fact that Infineon offers the following product as part of the Infineon product portfolio does not lead to any changes to this document. Future revisions will occur when appropriate, and any changes will be set out on the document history page. Continuity of ordering part numbers Infineon continues to support existing part numbers. Please continue to use the ordering part numbers listed in the datasheet for ordering. www.infineon.comEZ-PD CCG4 USB Type-C Port Controller EZ-PD CCG4, USB Type-C Port Controller General Description EZ-PD CCG4 is a dual USB Type-C controller that complies with the latest USB Type-C and PD standards. EZ-PD CCG4 provides a complete dual USB Type-C and USB-Power Delivery port control solution for notebooks, power adapters and docking stations. It can also be used in dual role and downstream facing port applications. EZ-PD CCG4 uses Cypresss proprietary M0S8 technology with a 32-bit, 48-MHz Arm Cortex -M0 processor with 128 KB flash and integrates two complete Type-C Transceivers including the Type-C termination resistors R and R . P D Integrated dead battery termination for DRP (Power Applications Source/Sink) applications Notebooks Supports two USB Type-C ports Power adapters Integrated VCONN FETs to power EMCA cables Docking stations Integrated fast role swap and extended data messaging (not supported for 33-ball CSP part) Features Low-Power Operation 32-bit MCU Subsystem 2.7-V to 5.5-V operation 48-MHz Arm Cortex-M0 CPU Independent supply voltage pin for GPIO that allows 1.71-V to 128-KB Flash 5.5-V signaling on the I/Os 8-KB SRAM Reset: 1.0 A, Deep Sleep: 2.5 A, Sleep: 2.5 mA Integrated Digital Blocks System-Level ESD on CC Pins Up to four integrated timers and counters to meet response 8-kV Contact Discharge and 15-kV Air Gap Discharge based times required by the USB-PD protocol on IEC61000-4-2 level 4C (on 40-pin QFN and 33-ball CSP Four run-time serial communication blocks (SCBs) with only) 2 re-configurable I C, SPI, or UART functionality Hot Swappable I/Os Clocks and Oscillators 2 Port 0 I C pins and CC1, CC2 pins are hot-swappable Integrated oscillator eliminating the need for external clock Packages Type-C and USB-PD Support 4.0 mm 4.0 mm, 0.5 mm, 24-pin QFN Integrated USB Power Delivery 3.0 support (only PD 2.0 support for 33-ball CSP part) 6.0 mm 6.0 mm, 0.6 mm, 40-pin QFN Two integrated USB-PD BMC transceivers 2.4 mm x 2.5 mm, 0.5 mm, 33-ball CSP 1 2 Integrated UFP (R ) and current sources for DFP (R ) on Supports extended industrial temperature range D P both Type-C ports (40 C to +105 C) Notes 1. UFP refers to Power Sink. 2. DFP refers to Power Source. Cypress Semiconductor Corporation 198 Champion Court San Jose, CA 95134-1709 408-943-2600 Document Number: 001-98440 Rev. *M Revised December 8, 2020