Please note that Cypress is an Infineon Technologies Company. The document following this cover page is marked as Cypress document as this is the company that originally developed the product. Please note that Infineon will continue to offer the product to new and existing customers as part of the Infineon product portfolio. Continuity of document content The fact that Infineon offers the following product as part of the Infineon product portfolio does not lead to any changes to this document. Future revisions will occur when appropriate, and any changes will be set out on the document history page. Continuity of ordering part numbers Infineon continues to support existing part numbers. Please continue to use the ordering part numbers listed in the datasheet for ordering. www.infineon.com EZ-PD CCG5 USB Type-C Port Controller EZ-PD CCG5, USB Type-C Port Controller General Description EZ-PD CCG5 is a dual USB Type-C controller that complies with the latest USB Type-C and PD standards. EZ-PD CCG5 provides a complete dual USB Type-C and USB-Power Delivery port control solution for PCs, notebook, and dock. It can also be used in dual role and downstream-facing port applications. EZ-PD CCG5 uses Cypress proprietary M0WS8 technology with a 32-bit, 48-MHz Arm Cortex -M0 processor with 128-KB flash and integrates two complete Type-C Transceivers including the Type-C termination 3 resistors, R and R . CCG5 also integrates high-voltage regulator. CCG5 is available in 40-QFN (1 port ) and 96-BGA (2 ports) P D packages. 32-bit MCU Subsystem Applications 48-MHz Arm Cortex-M0 CPU PCs, Notebook, and Dock 128-KB Flash Thunderbolt hosts and devices 12-KB SRAM Features Integrated Digital Blocks Up to two integrated timers and counters to meet response Type-C and USB-PD Support times required by the USB-PD protocol Integrated USB Power Delivery (USB-PD) 3.0 support Four run-time serial communication blocks (SCBs) with 2 Two integrated USB-PD Type-C ports reconfigurable I C, SPI, or UART functionality 1 2 Integrated UFP (R ) and current sources for DFP (R ) on D P Clocks and Oscillators both Type-C ports Integrated oscillator eliminating the need for an external clock Integrated dead battery termination for DRP (Power Source/Sink) applications Low-Power Operation Integrated VCONN FETs to power EMCA cables 2.75 V to 21.5 V operation Integrated fast role swap and extended data messaging System-Level ESD on CC, D, and SBU Pins Integrated high-voltage LDO, operational up to 21.5 V 8-kV Contact Discharge and 15-kV Air Gap Discharge based Integrated 2x USB Analog Mux on IEC61000-4-2 level 4C Integrated 2x SBU Analog Mux Integrated 2x USB Charger detect blocks BC v1.2, Apple Hot-Swappable I/Os Charging (source only) 2 Port 1 I C pins and CC1, CC2 pins are hot-swappable Integrated overvoltage protection (OVP) and overcurrent protection (OCP) on the VBUS Packages Integrated OCP protection on the VCONN 6.0 mm 6.0 mm, 0.6 mm, 40-pin QFN 6.0 mm 6.0 mm, 1.0 mm, 96-ball BGA Integrated high-voltage protection on CC and SBU pins to protect against accidental shorts to the VBUS pin on the Type-C Supports industrial temperature range (40 C to +85 C) connector Integrated current sense amplifier that supports high-side current sensing Integrated gate drivers for external VBUS PFET control on Type-C Ports Supports high-voltage tolerant PFET-controlled GPIOs Notes 1. UFP refers to Power Sink. 2. DFP refers to Power Source. 3. NRND (Not Recommended for New Designs). Refer to the CCG5C Datasheet for pin to pin compatible replacement part. Cypress Semiconductor Corporation 198 Champion Court San Jose, CA 95134-1709 408-943-2600 Document Number: 002-17682 Rev. *M Revised March 28, 2019