Please note that Cypress is an Infineon Technologies Company. The document following this cover page is marked as Cypress document as this is the company that originally developed the product. Please note that Infineon will continue to offer the product to new and existing customers as part of the Infineon product portfolio. Continuity of document content The fact that Infineon offers the following product as part of the Infineon product portfolio does not lead to any changes to this document. Future revisions will occur when appropriate, and any changes will be set out on the document history page. Continuity of ordering part numbers Infineon continues to support existing part numbers. Please continue to use the ordering part numbers listed in the datasheet for ordering. www.infineon.comEZ-PD CCG6DF, CCG6SF USB Type-C Port Controller EZ-PD CCG6DF, CCG6SF, USB Type-C Port Controller General Description EZ-PD CCG6DF and EZ-PD CCG6SF are dual-port and single-port USB Type-C controllers that comply with the latest USB Type-C and PD specifications. These devices provide a complete USB Type-C and USB-Power Delivery port control solution for PCs and notebooks. Both of these devices include a VBUS provider path load switch. These devices also contain a True Random Number Generator for authentication, a 32-bit, 48-MHz Arm Cortex -M0 processor with 64-KB flash and 96-KB ROM, integrating a complete Type-C Transceiver including the Type-C termination resistors Rp, Rd, and dead battery Rd termination. CCG6DF is available in a 96-ball BGA package, whereas CCG6SF is available in 48-pin QFN package. In response to Fast Role Swap request, turns OFF external Applications consumer N-channel Field Effect Transistor (NFET) and turns ON internal provider load switch Notebooks and desktops Thunderbolt hosts, non-Thunderbolt hosts LDO Features Integrated high-voltage LDO operational up to 21.5 V for dead battery mode operation USB-PD 32-bit MCU Subsystem Supports latest USB PD 3.0 specification 48-MHz Arm Cortex-M0 CPU Fast Role Swap (FRS) 64-KB Flash Extended Data Messaging 96-KB ROM Type-C 16-KB SRAM 1 Integrated current sources for DFP role (Rp) Integrated Digital Blocks Default current at 900 mA Two integrated timers and counters to meet response times 1.5 A required by the USB-PD protocol 3 A Four run-time serial communication blocks (SCBs) with 2 2 Integrated Rd resistor for UFP role reconfigurable I C, SPI, or UART functionality Integrated VCONN FETs to power EMCA cables Authentication Integrated dead battery termination True Random Number Generator Integrated high-voltage protection on CC and SBU pins to protect against accidental shorts to the VBUS pin on the Type-C Clocks and Oscillators connector Integrated oscillator eliminating the need for an external clock Integrated pass through SBU Switch for 20-V protection Operating Range Mux VSYS (2.75 V5.5 V) Integrated USB 2.0 Analog Mux for USB 2.0 HS and UART VBUS (4 V21.5 V) data Hot-Swappable I/Os Integrated Provider VBUS Load Switch 2 I C pins from SCB0 are hot-swappable VBUS Provider Switch (5 V/3A) Slew rate controlled turn-on on the VBUS provider path, Packages tolerant to 24 V CCG6DF: 6.0 mm 6.0 mm 1.0 mm, 96-ball BGA with 0.5-mm Configurable hardware-controlled VBUS overvoltage, under- pitch voltage, overcurrent, short circuit, reverse current protection, CCG6SF: 6.0 mm 6.0 mm 0.6 mm, 48-pin QFN with 0.4-mm and thermal shutdown pitch VBUS high-side current sense amplifier capable of measuring current across 5-m series resistance on the provider path Notes 1. DFP refers to power source. 2. UFP refers to power sink. Cypress Semiconductor Corporation 198 Champion Court San Jose, CA 95134-1709 408-943-2600 Document Number: 002-27161 Rev. *H Revised July 23, 2020