Series PVA13NPbF Microelectronic Power IC HEXFET Power MOSFET Photovoltaic Relay Single-Pole, Normally-Open, 0-100V AC/DC, 375mA General Description Features The PVA13 Series AC Relay (PVA) is a single-pole, Bounce-Free Operation normally open, solid-state replacement for 10 10 Off-State Resistance electromechanical relays used for general purpose 1,000 V/sec dv/dt switching of analog signals. It utilizes International 5 mA Input Sensitivity Rectifiers HEXFET power MOSFETs as the output 4,000 V I/O Isolation switches, driven by an integrated circuit photovoltaic RMS Solid-State Reliability generator of novel construction. The output switch is UL Recognized controlled by radiation from a GaAlAs light emitting diode (LED), which is optically isolated from the ESD Tolerance: photovoltaic generator. 4000V Human Body Model The PVA13 Series overcomes the limitations of both 500V Machine Model conventional electromechanical and reed relays by offering the solid state advantages of long life, fast operating speed, low pick up power, bounce-free operation, low thermal offset voltages and miniature package. These advantages allow product improvement and design innovations in many applications such as process control, multiplexing, automatic test equipment and data acquisition. The PVA13 can switch analog signals from thermocouple level to 100 Volts peak AC or DC polarity. Signal frequencies into the RF range are easily controlled and switching rates up to 450Hz are achievable. The extremely small thermally generated offset voltages allow increased measurement accuracies. These relays are packaged in 8-pin, molded DIP packages and available with either thru-hole or surface-mount (gull-wing) leads, in plastic shipping Part Identification tubes. PVA1352NPbF Applications thru-hole PVA1354NPbF Process Control surface-mount PVA1352NSPbF Data Acquisition (gull-wing) PVA1354NSPbF Test Equipment surface-mount PVA1354NS-TPbF Multiplexing and Scanning tape and reel (HEXFET is the registered trademark for International Rectifier Power MOSFETs) 1 www.irf.com 2015 International Rectifier Submit Datasheet Feedback April 24, 2015Series PVA13NPbF Electrical Specifications (-40C T +85C unless otherwise specified) A INPUT CHARACTERISTICS PVA1352N PVA1354N Units Minimum Control Current (see figures 1 and 2) DC For 325mA Continuous Load Current 2 mA 25C For 370mA Continuous Load Current 5 mA 40C For 190mA Continuous Load Current 5 mA 85C Maximum Control Current for Off-State Resistance at 25C 10 A(DC) Control Current Range (Caution: current limit input LED. See figure 6) 2.0 to 25 mA(DC) Maximum Reverse Voltage 6.0 V(DC) OUTPUT CHARACTERISTICS PVA1352N PVA1354N Units Operating Voltage Range 0 to 100 V (peak) Maxiumum Load Current 40C, I LED 5mA 375 mA(DC) Response Time 25C (see figures 7 and 8) Maximum T 12mA Control, 50 mA Load, 50 VDC 150 s (on) Maximum T 12mA Control, 50 mA Load, 50 VDC 125 s (off) Maximum On-state Resistance 25C (Pulsed) (figure 4) 50 mA Load, 5mA Control 5 8 10 Minimum Off-state Resistance 25C 80 VDC (see figure 5) 10 10 Maximum Thermal Offset Voltage 5.0mA Control 0.2 volts Minimum Off-State dv/dt 1000 V/s Typical Output Capacitance (see figure 9) 11pF 50VDC GENERAL CHARACTERISTICS (PVA1352N and PVA1354N) Units Dielectric Strength: Input-Output 4000 V RMS 12 Insulation Resistance: Input-Output 90V 10 25C - 50% RH DC Maximum Capacitance: Input-Output 1.0 pF Max. Pin Soldering Temperature (1.6mm below seating plane, 10 seconds max.) +260 Ambient Temperature Range: Operating -40 to +85 C Storage -40 to +100 International Rectifier does not recommend the use of this product in aerospace, avionics, military or life support applications. Users of this International Rectifier product in such applications assume all risks of such use and indemnify International Rectifier against all damages resulting from such use. 2 www.irf.com 2015 International Rectifier Submit Datasheet Feedback April 24, 2015