Series PVN013PbF Microelectronic Power IC HEXFET Power MOSFET Photovoltaic Relay Single-Pole, Normally-Open, 0-20V, 2.5A AC / 4.5A DC General Description Features The PVN013 Series Photovoltaic Relay at 100 milliohms features the lowest possible on-state 100m On-Resistance resistance in a miniature package lower than a Extremely low off-state leakage comparable reed relay. Bounce-free operation The PVN013 is a single-pole, normally open solid- 2.5 - 4.5 Amp capacity state relay. It utilizes a GenerationV HEXFET output Linear AC/DC operation switch, driven by an integrated circuit photovoltaic 4,000 V I/O isolation generator of novel construction. The output switch RMS Solid-State reliability is controlled by radiation from a GaAlAs light UL recognized emitting diode (LED) which is optically isolated from the photovoltaic generator. ESD Tolerance: These units exceed the performance capabilities 4000V Human Body Model of electromechanical relays in life, sensitivity, stable 500V Machine Model on-resistance, low off-state leakage, miniaturization, magnetic insensitivity and ruggedness. They are ideally suited for switching high currents or low level signals without distortion or injection of electrical noise. Series PVN013 Relays are packaged in a 6-lead molded DIP package with either thru-hole or surface mount (gull-wing) terminals. They are available in standard plastic shipping tubes or on tape-and-reel. Please refer to part identification information opposite. Applications Portable Electronics Industrial Control Part Identification Computers and Peripheral Devices PVN013PbF thru-hole Audio Equipment PVN013SPbF surface-mount Power Supplies and Power Distribution PVN013S-TPbF surface-mount, tape and reel Instrumentation (HEXFET is the registered trademark for International Rectifier Power MOSFETs) 1 www.irf.com 2015 International Rectifier Submit Datasheet Feedback May 12, 2015Series PVN013PbF Electrical Specifications (-40C T +85C unless otherwise specified) A INPUT CHARACTERISTICS Limits Units Minimum Control Current (see figure 1) 3.0 mA Maximum Control Current for Off-State Resistance T = +25C 0.4 mA A Control Current Range (Caution: current limit input LED, see figure 6) 3.0 to 25 mA Maximum Reverse Voltage 6.0 V OUTPUT CHARACTERISTICS Limits Units Operating Voltage Range 0 to 20 V (DC or AC peak) Maximum Continuous Load Current T =+40C, 5mA Control (see figure 1) A A Connection 2.5 A (DC or AC) B Connection 3.0 A (DC) C Connection 4.5 A (DC) Maximum Pulsed Load Current T =+25C, (100 ms 10% duty cycle) A A Connection 6.0 A (DC or AC) Maximum On-State Resistance T =+25C, for 1A pulsed load, 5mA Control (see figure 4) A A Connection 100 B Connection 65 m C Connection 40 Maximum Off-State Leakage T =+25C, 16V 10 nA A DC Maximum Turn-On Time T =+25C (see figure 7), for 1A, 20 V load, 5mA Control 5.0 ms A DC Maximum Turn-Off Time T =+25C (see figure 7), for 1A, 20 V load, 5mA Control 0.5 ms A DC Maximum Output Capacitance 20V (see figure 2) 300 pF DC GENERAL CHARACTERISTICS Limits Units Minimum Dielectric Strength, Input-Output 4000 V RMS 12 Minimum Insulation Resistance, Input-Output, T =+25C, 50%RH, 100V 10 A DC Maximum Capacitance, Input-Output 1.0 pF Maximum Pin Soldering Temperature (10 seconds maximum) +260 Ambient Temperature Range: Operating -40 to +85 C Storage -40 to +100 International Rectifier does not recommend the use of this product in aerospace, avionics, military or life support applications. Users of this International Rectifier product in such applications assume all risks of such use and indemnify International Rectifier against all damages resulting from such use. Connection Diagrams 2 www.irf.com 2015 International Rectifier Submit Datasheet Feedback May 12, 2015