Programmable USB TypeC Controller w/PD FUSB302T Description The FUSB302T targets system designers looking to implement USB TypeC wall charger or Travel adaptor. In addition to the default www.onsemi.com SRC function, the device supports DRP/ SRC/ SNK with low amount of programmability. The FUSB302T enables the USB Type-C detection including attach/detach, and orientation. The FUSB302T integrates the physical layer of the USB BMC power delivery protocol to allow up to 100 W of power and role swap. The BMC PD block enables full support for alternative interfaces of the Type-C specification. WQFN14 CASE 510BR Features Dual-role Functionality with Autonomous DRP Toggle ORDERING INFORMATION Ability to Connect as Either a Host or a Device Based on What Has See detailed ordering and shipping information on page 2 of Been Attached this data sheet. Software Configurable Either as a Dedicated Host, Dedicated Device, or Dual Role Dedicated Devices can Operate both on a Type-C Receptacle or a Type-C Plug with a Fixed CC and VCONN Channel Full Type-C 1.2 Support. Integrates the Following Functionality of the CC Pin: Attach/Detach Detection as Host Current Capability Indication as Host Current Capability Detection as Device Audio Adapter Accessory Mode Debug Accessory Mode Active Cable Detection Integrates CCx to VCONN Switch with Over-current Limiting for Powering USB3.1 Full Featured Cables USB Power Delivery (PD) 2.0 Support: Automatic GoodCRC Packet Response Automatic Retries of Sending a Packet if a GoodCRC is Not Received Automatic Soft Reset Packet Sent with Retries if Needed Automatic Hard Reset Ordered Set Sent Default CC Open for SRC Application Low Power Operation: I = 25 A (Typical) CC AECQ100 Qualified and PPAP Capable Packaged in: 14-lead WQFN (2.5 mm 2.5 mm, 0.5 mm Pitch) Applications Charging/Wall Adaptors Power Adapters Automotive Cigarette Adapters Automotive Laptops, Notebooks Semiconductor Components Industries, LLC, 2016 1 Publication Order Number: May, 2021 Rev. 5 FUSB302T/DFUSB302T OVP Charger USB Type-C Connector VBUS VCONN FUSB302T CC1 USB Type-C 2 Detection I C Control PD CC2 Processor USB Switch TX1/RX1 USB 3.1 TX2/RX2 5Gbps Figure 1. Block Diagram Table 1. ORDERING INFORMATION Operating Temperature Range Part Number Top Mark Package Packing Method FUSB302TMPX GS 40 to 85C FUSB302TVMPX YD WQFN14 2.5 mm 2.5 mm, FUSB302TV01MPX YE Tape and Reel Automotive 0.5 mm Pitch, (PbFree) 40 to 105C FUSB302TV10MPX YF FUSB302TV11MPX YG For information on tape and reel specifications, including part orientation and tape sizes, please refer to our Tape and Reel Packaging Specifications Brochure, BRD8011/D. www.onsemi.com 2