Ordering number : ENA1876C LV5692P Bi-CMOS IC LV5692P Specifications Absolute Maximum Ratings at Ta = 25C Parameter Symbol Conditions Ratings Unit Power supply voltage Vmax 36 V CC Power dissipation Pd max IC unit Ta 25C 1.5 W At using Al heat sink 5.6 W At infinity heat sink 32.5 W Peak voltage V peak Regarding Bias wave, refer to below the 50 V CC Junction temperature Tj max 150 C Operating temperature Topr -40 to +85 C Storage temperature Tstg -55 to +150 C Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality should not be assumed, damage may occur and reliability may be affected. Recommended Operating Conditions at Ta = 25C Parameter Conditions Ratings Unit Power supply voltage rating 1 V output ON, DSP output ON 7 to 16 V DD Power supply voltage rating 2 ILM output ON 10.8 to 16 V Power supply voltage rating 3 Audio output ON, CD output ON 10 to 16 V Functional operation above the stresses listed in the Recommended Operating Ranges is not implied. Extended exposure to stresses beyond the Recommended Operating Ranges limits may affect device reliability. Electrical Characteristics at Ta = 25 C, V = V 1 = 14.4V CC CC Ratings Parameter Symbol Conditions Unit min typ max Current drain I V no load, CTRL1/2/3 = L/L/L 50 100 A CC DD CTRL1 Input Low input voltage V1 0 0.3V IL Middle input voltage V1 1.1 1.65 2.1V IM High input voltage V1 2.5 5.5V IH Input impedance R1 280 400 520k IH CTRL2 Input Low input voltage V2 0 0.3V IL Middle1 input voltage V2 0.8 1.06 1.4 V IM1 Middle2 input voltage V2 1.9 2.13 2.4 V IM2 High input voltage V2 2.9 3.2 5.5V IH Input impedance R2 280 400 520k IH CTRL3 input. Low input voltage V3 0 0.3V IL High input voltage V3 2.5 5.5V IH Input impedance R3 280 400 520k IH V 3.3V output DD Output voltage V1 I 1 = 200mA 3.16 3.3 3.45 V O O Output current I1 V 1 3.1V 300 mA O O Line regulation V1 7.5V < V 1 < 16V, I 1 = 200mA 30 100 mV OLN CC O Load regulation V1 1mA < I 1 < 200mA 70 150 mV OLD O Ripple rejection R 1 f = 120Hz, I 1 = 200mA 30 40 dB REJ O USB output: CTRL3 = H (When external power FET 2SJ650, it external resists 27k, and 9.1k is set) USB output voltage V2 I 2 = 1000mA 4.75 5 5.25 V O O USB output current I2 V 2 4.75V 1000 mA O O Line regulation V2 10V < V < 16V, I 2 = 1000mA 50 90 mV OLN CC O Load regulation V2 10mA < I 2 < 1000mA 100 150 mV OLD O Dropout voltage V 2 I 2 = 1000mA 1.0 1.5 V DROP O Ripple rejection R 1 f = 120Hz, I 2 = 1000mA 40 50 dB REJ O Continued on next page. No.A1876-2/15