TQP3M9007 1/4 W High Linearity LNA Gain Block Product Description The TQP3M9007 is a high linearity low noise gain block amplifier in a low-cost surface-mount package. At 1.9 GHz, the amplifier typically provides 13dB gain, +41dBm OIP3, and 1.3dB Noise Figure while drawing 125mA current. SOT-89 Package The device is housed in a lead-freegreenRoHS compliantindustry-standard SOT-89 package. Product Features The TQP3M9007 has the benefit of having high linearity 1004000MHz while also providing very low noise across a broad range of 13dB Gain at 1.9GHz frequencies. This allows the device to be used in both 1.3dB Noise Figure at 1.9GHz receive and transmit chains for high performance systems. The amplifier is internally matched using a high- +41dBm Output IP3 performance E-pHEMT process and only requires an +23.6dBm P1dB external RF choke and blocking/bypass capacitors for 50 Cascadable Gain Block operation from a single +5V supply. The internal active Unconditionally Stable bias circuit also enables stable operation over bias and temperature variations. High Input Power Capability +5V Single Supply, 125mA Current The TQP3M9007 covers the 0.14 GHz frequency band SOT-89 Package and is targeted for wireless infrastructure or other applications requiring high linearity and/or low noise figure. Applications Functional Block Diagram Repeaters Mobile Infrastructure LTE / WCDMA / CDMA / EDGE GND General Purpose Wireless 4 1 2 3 RF IN GND RF OUT Ordering Information Part No. Description TQP3M9007 1000 pieces on a 7 reel (standard) TQP3M9007-PCB 0.54 GHz Evaluation Board Datasheet, May 13, 2021 Subject to change without notice 1 of 13 www.qorvo.com TQP3M9007 1/4 W High Linearity LNA Gain Block Absolute Maximum Ratings Recommended Operating Conditions Parameter Rating Parameter Min Typ Max Units Storage Temperature 55 to +150C Device Voltage (VDD) +3.0 +5.0 +5.25 V RF Input Power, CW, 50, T=25C +20dBm TCASE 40 +105 C 6 Device Voltage (VDD) +7 V Tj for >10 hours MTTF +190 C Electrical specifications are measured under bias, signal and Exceeding any one or a combination of the Absolute Maximum Rating temperature conditions as specified. Specifications are not guaranteed conditions may cause permanent damage to the device. Extended application of Absolute Maximum Rating conditions to the device may over all recommended operating conditions. reduce device reliability. Electrical Specifications Parameter Conditions Min Typ Max Units Operational Frequency Range 100 4000 MHz Test Frequency 1900 MHz Gain 11.5 13 14.5 dB Input Return Loss 18 dB Output Return Loss 13 dB Output P1dB +23.6 dBm Output IP3 See Note 1. +37 +41 dBm Noise Figure 1.3 dB Current, IDD 125 150 mA Thermal Resistance, jc Junction to backside ground paddle 52 C/W Notes: 1. Test conditions unless otherwise noted: V =+5V, Temp=+25C, 50 system DD 2. OIP3 is measured with two tones at an output power of 4dBm / tone separated by 1MHz. The suppression on the largest IM3 product is used to calculate the OIP3 using 2:1 rule. 2:1 rule gives relative value with respect to fundamental tone. Datasheet, May 13, 2021 Subject to change without notice 2 of 13 www.qorvo.com
