HA-2600
Data Sheet January 16, 2006 FN2902.7
12MHz, High Input Impedance Operational Features
Amplifier
Bandwidth . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12MHz
HA-2600 is an internally compensated bipolar operational
High Input Impedance . . . . . . . . . . . . . . . . . . . . . 500M
amplifier that features very high input impedance (500M)
Low Input Bias Current. . . . . . . . . . . . . . . . . . . . . . . . 1nA
coupled with wideband AC performance. The high
resistance of the input stage is complemented by low offset
Low Input Offset Current . . . . . . . . . . . . . . . . . . . . . . 1nA
voltage (0.5mV) and low bias and offset current (1nA) to
Low Input Offset Voltage . . . . . . . . . . . . . . . . . . . . 0.5mV
facilitate accurate signal processing. Input offset can be
reduced further by means of an external nulling
High Gain . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 150kV/V
potentiometer. 12MHz unity gain-bandwidth, 7V/s slew rate
Slew Rate. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7V/s
and 150kV/V open-loop gain enables the HA-2600 to
perform high-gain amplification of fast, wideband signals. Output Short Circuit Protection
These dynamic characteristics, coupled with fast settling
Unity Gain Stable
times, make this amplifier ideally suited to pulse
amplification designs as well as high frequency (e.g. video)
Applications
applications. The frequency response of the amplifier can be
Video Amplifier
tailored to exact design requirements by means of an
external bandwidth control capacitor.
Pulse Amplifier
In addition to its application in pulse and video amplifier Audio Amplifiers and Filters
designs, the HA-2600 is particularly suited to other high
High-Q Active Filters
performance designs such as high-gain low distortion audio
High-Speed Comparators
amplifiers, high-Q and wideband active filters and high-
speed comparators.
Low Distortion Oscillators
Pinout
Ordering Information
HA-2600 (METAL CAN)
TOP VIEW
PART PART TEMP. PKG.
NUMBER MARKING RANGE (C) PACKAGE DWG. #
COMP
HA2-2600-2 HA2-2600-2 -55 to 125 8 Pin Metal Can T8.C
8
1 7
BAL V+
-
6
2
-IN OUT
+
3 5
+IN BAL
4
V-
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1
1-888-INTERSIL or 1-888-468-3774 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2002, 2006. All Rights ReservedHA-2600
Absolute Maximum Ratings Thermal Information
Supply Voltage Between V+ and V- Terminals . . . . . . . . . . . . . 45V Thermal Resistance (Typical, Note 1) (C/W) (C/W)
JA JC
Differential Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12V Metal Can Package . . . . . . . . . . . . . . . 165 80
Peak Output Current . . . . . . . . . . . . . . . Full Short Circuit Protection Maximum Junction Temperature (Hermetic Package) . . . . . . . . 175C
Maximum Storage Temperature Range . . . . . . . . . -65C to 150C
Maximum Lead Temperature (Soldering 10s) . . . . . . . . . . . . 300C
Operating Conditions
Temperature Range
HA-2600-2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -55C to 125C
CAUTION: Stresses above those listed in Absolute Maximum Ratings may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTE:
1. is measured with the component mounted on a low effective thermal conductivity test board in free air. See Tech Brief TB379 for details.
JA
Electrical Specifications V = 15V, Unless Otherwise Specified
SUPPLY
PARAMETER TEMP. (C) MIN TYP MAX UNITS
INPUT CHARACTERISTICS
Offset Voltage 25 - 0.5 4 mV
Full - 2 6 mV
Average Offset Voltage Drift Full - 5 - V/C
Bias Current 25 - 1 10 nA
Full - 10 30 nA
Offset Current 25 - 1 10 nA
Full - 5 30 nA
Differential Input Resistance (Note 11) 25 100 500 - M
Input Noise Voltage Density (f = 1kHz) 25 - 11 - nV/Hz
Input Noise Current Density (f = 1kHz) 25 - 0.16 - pA/Hz
Common Mode Range Full 11 12 - V
TRANSFER CHARACTERISTICS
Large Signal Voltage Gain (Notes 2, 5) 25 100 150 - kV/V
Full 70 - - kV/V
Common Mode Rejection Ratio (Note 3) Full 80 100 - dB
Minimum Stable Gain 25 1 - - V/V
Gain Bandwidth Product (Note 4) 25 - 12 - MHz
OUTPUT CHARACTERISTICS
Output Voltage Swing (Note 2) Full 10 12 - V
Output Current (Note 5) 25 15 22 - mA
Full Power Bandwidth (Notes 5, 12) 25 50 75 - kHz
TRANSIENT RESPONSE (Note 11)
Rise Time (Notes 2, 6, 7, 8) 25 - 30 60 ns
Overshoot (Notes 2, 6, 7, 9) 25 - 25 40 %
Slew Rate (Notes 2, 6, 8, 13) 25 4 7- V/s
Settling Time (Notes 2, 6, 14) 25 - 1.5 - s
FN2902.7
2
January 16, 2006