SF2200E Surface Mount 3.0 x 3.0 mm Package Complies with Directive 2002/95/EC (RoHS) Pb 707 MHz Absolute Maximum Ratings SAW Filter Rating Value Units Input Power Level 20 dBm DC Voltage on any Non-ground Terminal 3 V Operable Temperature Range -45 to +125 C Specification Temperature Range -40 to +85 C Storage Temperature Range in Tape and Reel -40 to +85 C Solder Reflow Temperature, 10 seconds, 5 cycles maximum 260 C SM3030-6 Electrical Characteristics Characteristic Sym Notes Min Typ Max Units Center Frequency f 707 MHz C Insertion Loss, 698 to 716 MHz IL 2.1 3.0 Amplitude Ripple, 698 to 716 MHz 0.5 1.5 dB Return Loss, 698 to 716 MHz 7 13 Attenuation, 0 dB Reference: 10 to 680 MHz 30 50 745 to 978 MHz 30 42 dB 978 to 996 MHz 35 58 996 to 2700 MHz 25 29 Source Impedance Z 50 S Load Impedance Z 50 L Case Style SM3030-6 3.0 x 3.0 mm Nominal Footprint Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator 930, YWWS Standard Reel Quantity Reel Size 7 Inch 500 Pieces/Reel Reel Size 13 Inch 3000 Pieces/Reel Electrical Connections Connection Terminals Input 2 Output 5 Case Ground All others CAUTION: Electrostatic Sensitive Device. Observe precautions for handling. NOTES: 1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance matching to 50 and measured with 50 network analyzer. 2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc. 3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external impedance matching design. See Application Note No. 42 for details. 4.LRI or after the part number indicateslow rate initial productio andEN or indicatesengineering prototypes 5. The design, manufacturing process, and specifications of this filter are subject to change. 6. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port 2, so that the filter must always be installed in one direction per the circuit design. 7. US and international patents may apply. 8. Murata, stylized Murata logo, and Murata N.A., Inc. are registered trademarks of Murata Manufacturing Co., Ltd. Copyright Murata Manufacturing Co., Ltd. All rights reserved. July 2010 SF2200E (R) 7/12/17 Page 1 of 5 www.murata.comFilter Response Plots 707 MHz filter 0 S21 -1 spec. -2 -3 -4 -5 -6 -7 -8 -9 -10 687 692 697 702 707 712 717 722 727 Freq.(MHz) 707 MHz filter 0 S21 -10 spec. -20 -30 -40 -50 -60 -70 -80 607 627 647 667 687 707 727 747 767 787 807 Freq.(MHz) Copyright Murata Manufacturing Co., Ltd. All rights reserved. July 2010 www.murata.com SF2200E (R) 7/12/17 Page 2 of 5 Att.(dB) Att.(dB)