TLP108 TOSHIBA PHOTOCOUPLER IRED & PHOTO-IC TLP108 Unit: mm Isolated bus drivers High speed line receivers Microprocessor system interfaces The Toshiba TLP108 consists of an infrared emitting diode optically coupled to a high-gain, high-speed photodetector. The TLP108 is housed in a 6-pin MFSOP. With a totem-pole output, the TLP108 is capable of both sinking and sourcing current. The TLP108 has an internal Faraday shield, which provides a guaranteed common-mode transient immunity. The TLP108 has an inverting output. A noninverting-output version, the TLP105, is also available. Inverter logic type (totem-pole output) Guaranteed Performance Over temperature: 40 to 100C JEDEC Power Supply Voltage: 4.5 to 20 V JEITA TOSHIBA 11-4C2 Input Threshold Current: I =1.6 mA (max) FHL Weight: 0.09 g (typ.) Switching Time (t /t ): 250 ns (max) pLH pHL Common mode transient immunity: 10 kV/s Pin Configuration (top View) Isolation Voltage: 3750 Vrms 1:ANODE V CC 1 6 UL-recognized: UL 1577, File No.E67349 3:CATHODE 4:GND 5 cUL-recognized: CSA Component Acceptance Service 5:V (Output) O GND No.5A File No.E67349 6:V 4 3 SHIELD CC VDE-approved: EN 60747-5-5 (Note1) Note1 : When a VDE approved type is needed, I CC Schematic Please designate the Option(V4). V CC 6 I F Tr1 1 I O Truth Table V F V O 3 Tr2 Input LED Tr1 Tr2 Output 5 ON OFF ON L H L OFF ON OFF H GND SHIELD 4 0.1 F bypass capacitor must be connected between pin 6 and 4. Start of commercial production 2008-04 2019 1 2019-06-10 Toshiba Electronic Devices & Storage Corporation TLP108 Recommended Operating Conditions Characteristics Synbol Min Typ. Max Unit Input Current , ON I 2 10 mA F(ON) Input Voltage , OFF V 0 0.8 V F(OFF) Supply Voltage* V 4.5 20 V CC Operating Temperature T -40 100 C opr Fan-out (TTL Load) N 4 * This item denotes operating range, not meaning of recommended operating conditions. Note: Recommended operating conditions are given as a design guideline to obtain expected performance of the device. Additionally, each item is an independent guideline respectively. In developing designs using this product, please confirm specified characteristics shown in this document. Absolute Maximum Ratings (Ta = 25C) Characteristics Synbol Rating Unit Forward Current I 20 mA F Forward Current Derating (Ta 83C) IF/ -0.48 mA/ Peak Transient Forward Current (Note 1) I 1 A FPT Input Power Dissipation P 40 mW D Reverse Voltage V 5 V R Output Current 1 (Ta 25) I 25/-15 mA O1 Output Current 2 (Ta 100) I 5/-5 mA O2 Output Current Derating (Ta 25C) I / -0.26/-0.13 mA/ O1 Peak Output Current (Note 2) I 50/-50 mA OP Output Voltage V -0.5 to 20 V O Output Power Dissipation P 75 mW O Supply Voltage V -0.5 to 20 V CC Operating Temperature Range T 40 to 100 opr Storage Temperature Range T 55 to 125 stg Lead Solder Temperature (10 s) T 260 sol Isolation Voltage BV 3750 V rms S (AC, 60 s, R.H. 60 %) (Note 3) Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings. Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook (Handling Precautions/Derating Concept and Methods) and individual reliability data (i.e. reliability test report and estimated failure rate, etc). Note 1: Pulse width 1 s, 300 pps. Note 2: Pulse width 5 s, duty cycle 0.025 Note 3: Device considered a two terminal device: pins 1 and 3 shorted together and pins 4, 5 and 6 shorted together. 2019 2 2019-06-10 Toshiba Electronic Devices & Storage Corporation DETECTOR LED