GL-60-10 Wakefield

ulTIMiFlux Thermal Gap Filling Line High Thermal Performing Fully Cured Dispensable Gels Wakefield-Vettes ulTIMiFlux fully cured dispensable gels eliminate time consuming hand assembly, decreasing installation costs and reducing customer manufacturing and purchasing (logistical) complexity. These products require no mixing or curing, providing superior design flexibility. The dispensable gels provides low thermal impedance at thin and thick gaps, allowing use of common heat spreaders with proven reliability in extreme temperature cycling and shock & vibration. These dispensable gels also deflect easily under very low compressive forces, decreasing stress on components thus decreasing component failures Typical Min WKV Part Syringe Size Flow Rate Specific Thermal Conductivity Operating Range Color Bondline Thickness Number (CC) (grams/min) Gravity (W/mK) (Celsius) (Inches) GL-20-10 10 Pink 20 3.20 0.004 3.5 -55 to 200 GL-08-10 10 Yellow 8 1.20 0.015 2.4 -55 to 200 GL-60-10 10 White 60 2.70 0.002 3.0 -55 to 200 Features / Benefits: Fully Cured Requires no refrigeration, mixing, or additional curing Proven long-term reliability and superior performance No settling occurs in storage Highly Conformable At Low Pressures Ideal for multiple thickness gaps under one common heat sink Applies very low stress on components, which makes it ideal for delicate applications Allows for design flexibility compared to thermal pads One Component Dispensable Applications: Eliminates hand assembly Automotive Electronic Control Units (ECUs) Decreases installation cost Power Supplies & Semiconductors Eliminates multiple pad part sizes/ numbers Memory & Power Modules Excellent Surface Wetting Microprocessors / Graphics Processors Excellent for maintaining contact through thermal Flat Panel Display cycling Installation Guidelines: Thermal gels are supplied in plastic syringes. Apply pressure to the rear of the cartridge, simply dispense the desired amount onto components or cooling plates. The gel is reworkable and excess material can be easily wiped off. Since GL-60-10 gel is conformable, the gel can be stencil printed onto the plates. The thickness of the printed gel can be adjusted depending on the component type and size, but about 6mil thickness is recommended. www.wakefield-vette.comX-ON Electronics Largest Supplier of Electrical and Electronic Components Click to view similar products for Thermal Interface Products category: Click to view products by Wakefield manufacturer: Other Similar products are found below : 7721-9PPS FGN80-2 PFM-172-60 A-40 174-9-230P 9601-7 5300AC 1.500G 08133 V6622C TVQF-1225-07S TP0001 4860 SC80-W2 V6516C A17713-06 A17713-05 A17690-06 A17775-03 A17690-05 A17690-03 A17653-02 A17689-02 A17690-04 A17775-05 A17775- 06 A17690-08 A17690-02 A17689-06 A17653-06 A17690-12 A17653-03 A17536-02 A17689-03 A17536-10 A17752-13 A17752-04 A17752-07 A17634-12 19-36565-0001-1 A17752-09 22000-001A A17752-20 A17752-16 A17752-12 A17653-04 A17634-10 A17634-09 A17634-07 A17633-20 A17633-07