POE16R-1AFG-R Phihong

WWW.PHIHONG.COM Single Port 15.4W Power over Ethernet Interchangeable Wall Plug* Adapter Power Injector *Plugs sold separately Features Fully Compliant with 10/100/1000/2500 data speed IEEE802.3af Lowest Cost Non-Vented Case Full Protection OCP, OVP Field Interchangeable AC Clips* Diagnostic LEDs 1 Year Warranty Level VI Efficiency select models Applications IP Telephones Security Cameras Wireless Network Access Points IP Print Servers Blue Tooth Access Points Safety Approvals cUL/UL 62368-1 IEC 62368-1 Mechanical Characteristics Length: 80mm (3.15in) Height: 33mm (1.29in) Width: 45mm (1.77in) Weight: 95g (3.35oz.) Output Specifications DC Output Load Output Data Regulation Model Efficiency Power Speed Voltage Min. Max. Line Load 1 POE16R-1AFG-R 56V 0A 0.275A 15.4W 1G none 54-57VDC Notes: 1. Not Recommended for New Designs (NRND) Phihong is not responsible for any error and reserves the right to make changes without notice. Please visit our website at www.phihong.com for the most up-to-date specifications and contact information. Revision 10/7/2020 1 POE16R-1AFG-R Characteristics WWW.PHIHONG.COM INPUT: EMC AC Input Voltage Range Complies with FCC Class B 90 to 264VAC Complies with EN55032 Class B AC Input Voltage Rating Immunity 100 to 240VAC ESD: EN61000-4-2. 6KV Contact/8KV Air AC Input Current RS: EN61000-4-3. 3V/M 0.8A (RMS) max for 90VAC EFT: EN61000-4-4. Level 2 0.5A (RMS) max for 240VAC Surge: EN61000-4-5. 1KV DM/2KV CM Leakage Current CS: EN61000-4-6. 3V 0.25mA max 254VAC 60Hz Voltage Dips EN61000-4-11 Harmonic: EN61000-3-2 Class A AC Input Frequency 47-63Hz Isolation Test Primary to Secondary: 3000VAC for 1 second AC Inrush Current 10mA 15A (RMS) max for 115VAC 20A (RMS) max for 230VAC Insulation Resistance Primary to Secondary: >10M OHM 500VDC OUTPUT: Total Output Power FEATURES: 15.4W Over Voltage/Current, Short Circuit Protection 2 Ripple and Regulation The output is equipped with short circuit 150mV max protection and overload protection as per IEEE802.3af specifications and conforms to 3 Efficiency UL60950-2. The output can be shorted 85% (typical) at max load, 120VAC 60Hz permanently without damage. Transient O/P Voltage Protection Hold-up Time 60V max at switch on/off, any AC line 16mS min. 120VAC and max load phase ENVIRONMENTAL: Temperature Operation 0 to +40C Non-operation -25 to +65C Humidity 5 to 90% Notes: 1. The characteristics defined are at ambient temperature of 25C unless otherwise specified 2. Measured with by-pass capacitors 0.1uf/10uf at output connector terminal and oscilloscope set at 20Mhz (tested by oscilloscope). 20 minutes warm-up required when operating at negative temperature. 3. Efficiency is measured after 30 minutes burn-in Revision 10/7/2020