TLP105 TOSHIBA PHOTOCOUPLER IRED & PHOTO-IC TLP105 Unit: mm Isolated bus drivers High-speed line receivers Microprocessor system interfaces The Toshiba TLP105 consists of an infrared emitting diode optically coupled to a high-gain, high-speed photodetector. The TLP105 is housed in a 6-pin MFSOP. With a totem-pole output, the TLP105 is capable of both sinking and sourcing current. The TLP105 has an internal Faraday shield, which provides a guaranteed common-mode transient immunity of 10 kV/ s. The TLP105 has a noninverting output. An inverting-output version, the TLP108, is also available. Buffer logic type (totem-pole output) JEDEC JEITA Guaranteed Performance Over Temperature: 40 to 100C TOSHIBA 11 4C2 Power Supply Voltage: 4.5 to 20 V Weight: 0.09 g (typ.) Input Threshold Current: I =1.6 mA (max) FLH Pin Configuration (top View) Switching Time (t /t ): 250 ns (max) pLH pHL 1:ANODE V CC 1 6 Common mode transient immunity: 10 kV/ s 3:CATHODE 4:GND Isolation Voltage: 3750 Vrms 5 5:V (Output) O UL-recognized: UL 1577, File No.E67349 GND 6:V 4 3 SHIELD CC cUL-recognized: CSA Component Acceptance Service No.5A I CC File No.E67349 Schematic V CC VDE-approved: EN 60747-5-5 (Note 1) 6 I F Tr1 1 Note 1 : When a VDE approved type is needed, I O please designate the Option(V4). V F V O Tr2 3 5 GND Truth Table SHIELD 4 Input LED Tr1 Tr2 Output 0.1 F bypass capacitor must be connected between pin 6 and 4. H ON ON OFF H L OFF OFF ON L Start of commercial production 2008-05 2019 1 2019-05-27 Toshiba Electronic Devices & Storage Corporation TLP105 Recommended Operating Conditions CHARACTERISTIC SYMBOL MIN TYP. MAX UNIT Input Current, ON I 2 10 mA F(ON) Input Voltage, OFF V 0 0.8 V F(OFF) Supply Voltage* V 4.5 20 V CC Operating Temperature T -40 100 C opr Fan-out (TTL Load) N 4 * This item denotes operating range, not meaning of recommended operating conditions. Note: Recommended operating conditions are given as a design guideline to obtain expected performance of the device. Additionally, each item is an independent guideline respectively. In developing designs using this product, please confirm specified characteristics shown in this document. Absolute Maximum Ratings (Ta = 25C) CHARACTERISTIC SYMBOL RATING UNIT Forward Current I 20 mA F Forward Current Derating (Ta 83C) IF/C -0.48 mA/C Peak Transient Forward Current (Note1) I 1 A FPT Reverse Voltage V 5 V R Input Power Dissipation P 40 mW D Input Power Dissipation derating (Ta 83C) PD/C -0.95 mW/C Output Current 1 (Ta 25C) I 25/-15 mA O1 Output Current 2 (Ta 100C) I 5/-5 mA O2 Output Current Derating (Ta 25C) IO1/C -0.26/-0.13 mA/C Peak Output Current (Note2) I 50/-50 mA OP Output Voltage V -0.5 to 20 V O Output Power Dissipation P 75 mW O Output Power Dissipation Derating (Ta 25C) P /C -0.75 mW/C O Supply Voltage V -0.5 to 20 V CC Operating Temperature Range T 40 to 100 C opr Storage Temperature Range T 55 to 125 C stg Lead Solder Temperature (10 s) T 260 C sol Isolation Voltage (AC, 60 s, R.H. 60 %) (Note3) BV 3750 V s rms Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings. Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook (Handling Precautions/Derating Concept and Methods) and individual reliability data (i.e. reliability test report and estimated failure rate, etc). Note 1: Pulse width 1 s, 300 pps. Note 2: Pulse width 5 s, duty cycle 0.025 Note 3: Device considered a two terminal device: pins 1 and 3 shorted together and pins 4, 5 and 6 shorted together. 2019 2 2019-05-27 Toshiba Electronic Devices & Storage Corporation DETECTOR LED