TORX1353(F) Toshiba

TORX1353(F) FIBER OPTIC RECEIVING MODULE TORX1353(F) GENERAL PURPOSE OPTICAL RECEIVING MODULE Data rate: DC to 500 kb / s (NRZ code) Transmission distance: 0.2m to 10 m (Using TOTX1353(F) and APF) For JIS F05 Optical Connector C-MOS Interface +5V Single Power Supply ATC (Automatic Threshold Control) circuit is used for stabilized output at a wide range of optical power level. Low current consumption 1.5 mA (max) (Active) 30 A (max) (Standby) 1. Absolute Maximum Ratings (Ta = 25C) Characteristics Symbol Rating Unit Storage Temperature T 40 to 95 C stg Operating Temperature T 40 to 85 C opr Supply Voltage V 0.5 to 6 V CC High Level Output Current I 1 mA OH Low Level Output Current I 20 mA OL Soldering Temperature T 260 (Note 1) C sol Note 1: Soldering time 10 s (More than 1 mm apart from the package). Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the significant change in temperature , etc) May cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/ current/ voltage, etc.) are within the absolute maximum ratings and the operating ranges. Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook (Handling Precautions/derating Concept and Methods) and individual reliability data (i.e. reliability test report and estimated failure rate, etc). 2. Operating Ranges Characteristics Symbol MinTyp.MaxUnit Supply Voltage V 4.75 5.0 5.25 V CC Data Rate DC 500 kb/s High Level Output Current I 0.8 mA OH Low Level Output Current I 0.8 mA OL Start of commercial production 2013/02 1 2014-05-20 TORX1353(F) 3. Electrical and Optical Characteristics (Ta = 25C, Vcc = 5 V) Characteristics Symbol Test Condition Min Typ. MaxUnit Data Rate NRZ Code(Note 2) DC 500 kb / s Transmission Distance(Note5) Using APF (Note3) and TOTX1353(F) 0.2 10 m Pulse Width Distortion (Note4)(Note5) tw 30 30 % Maximum Receivable Power (Note 6) P DC to 500 kb / s, Using APF(Note 3) 11 dBm MAX Minimum Receivable Power (Note 6) P DC to 500 kb / s, Using APF(Note 3) 23.5 dBm MIN Active I 0.3 1.5 mA CC(1) (Optical flux on) Current Consumption Standby I 20 30 A CC(2) (No optical flux on) High Level Output Voltage V 4.2 4.8 V OH Low Level Output Voltage V 0.2 0.4 V OL Note 2: High level output when optical flux is received. Low level output when it is not received. Note 3: All Plastic Fiber (980m core / 1000m cladding, NA=0.5), Polished surface. Note 4: Between input of driver circuit of TOTX1353(F) and output of TORX1353(F). Note 5: A value changes with LED drive circuits. 9 Note 6: BER 10 , Valued by peak. 4. Application Circuit Fiber optic connector insertion side TORX1353(F) Soldered to PC board Soldered to PC board Less than 7mm 0.1 F Vcc GND Output (Bottom View) 5. Applicable Optical Fiber with Fiber Optic Connectors All Plastic Fiber (980m core / 1000m cladding), NA=0.5 F05 type optical connector with polished surface. 2 2014-05-20