63900-1770 Molex

Fine Adjust Applicator for Mini Fit H20 Male and Female Crimp Terminals FineAdjust Applicator Specification Sheet Order No. 63900-1700 FEATURES Quick punch removal with the push of a button for fast and easy tooling change Applicator designed to industry standard mounting and shut height 135.80mm (5.346 ) Quick set-up time plus the crimp height, track and feed adjustments can be set without removing the applicator from the press Fine adjustment allows users to achieve target with little effort by adjusting in increments of .015mm (.0006 ) for conductor crimp height and .063mm (.0025 ) for insulation height Independent adjustment rings allow users to quickly adjust the conductor or insulation crimp height without affecting each other Directly adapts to most automatic wire processing machines SCOPE Products: Sealed Mini Fit H20 Male and Female Crimp Terminals, 18 - 20 AWG. Wire Size Insulation Diameter Strip Length Terminal Series No. Terminal Order No. AWG mm mm In. mm In. 46055-0004 46055 18-20 0.80-0.50 2.52-2.81 .099-.111 2.60-3.10 .102-.122 46055-0005 46055-0006 46056-0001 46056 18-20 0.80-0.50 2.52-2.81 .099-.111 2.60-3.10 .102-.122 46056-0002 46056-0003 BEND UP DEFINITION OF TERMS ROLLING SEAM BELL CONDUCTOR BRUSH MOUTH CRIMP INSULATION CRIMP TWISTING STRIP LENGTH BEND DOWN CUT-OFF CRIMP HEIGHT TAB The above terminal drawing is a generic terminal representation. It is not an image of a terminal listed in the scope. Doc No: ATS- 639001700 Release Date: 02-21-08 UNCONTROLLED COPY Page 1 of 5 Revision: A Revision Date: 02-21-08 Fine Adjust Applicator for Mini Fit H20 Male and Female Crimp Terminals CRIMP SPECIFICATION Bell mouth Cut-off Tab Maximum Conductor Brush Terminal Series No. mm In. mm In. mm In. 46055 0.25-1.25 .010-.049 0.50 .020 0.15-0.40 .006-.016 46056 0.25-1.25 .010-.049 0.50 .020 0.15-0.40 .006-.016 Bend up Bend down Twist Roll Punch Width (Ref) Seam Terminal Series No. Conductor Insulation Degree Degree Seam shall not be mm In mm In open and no wire allowed 46055 3 3 3 3 1.60 .063 2.75 .108 out of the crimping area 46056 3 3 3 3 1.60 .063 2.75 .108 After crimping, the conductor profile should measure the following. Conductor Insulation Wire Size Pull Force Minimum Terminal Series No. Crimp Height Crimp Height Maximum 2 AWG mm mm In. mm In. N Lb. 18 0.80 1.05-1.15 .041-.045 3.20 .126 89.0 20.0 46055 20 0.50 1.00-1.10 .039-.043 3.20 .126 57.8 13.0 18 0.80 1.05-1.15 .041-.045 3.20 .126 89.0 20.0 46056 20 0.50 1.00-1.10 .039-.043 3.20 .126 57.8 13.0 Pull Force should be measured with no influence from the insulation crimp. The above specifications are guidelines to an optimum crimp. Doc No: ATS- 639001700 Release Date: 02-21-08 UNCONTROLLED COPY Page 2 of 5 Revision: A Revision Date: 02-21-08