MBR2545CTG ON Semiconductor

MBR2535CTG, MBR2545CTG Switchmode Power Rectifiers The MBR2535CTG/45CTG series uses the Schottky Barrier MBR2535CTG, MBR2545CTG MAXIMUM RATINGS Rating Symbol Value Unit Peak Repetitive Reverse Voltage V V RRM Working Peak Reverse Voltage V RWM DC Blocking Voltage V R MBR2535CTG 35 MBR2545CTG 45 Average Rectified Forward Current I A F(AV) (Rated V , T = 160C) R C Per Device 30 Per Diode 15 Peak Repetitive Forward Current I A FRM per Diode Leg (Rated V , Square Wave, 20 kHz, T = 150C) 30 R C Non-Repetitive Peak Surge Current per Diode Leg I A FSM (Surge Applied at Rated Load Conditions, Halfwave, Single Phase, 60 Hz) 150 Peak Repetitive Reverse Surge Current (2.0 s, 1.0 kHz) I 1.0 A RRM Storage Temperature Range T 65 to +175 C stg Operating Junction Temperature (Note 1) T 65 to +175 C J Voltage Rate of Change (Rated V ) dv/dt 10,000 V/ s R ESD Ratings: ESD V Machine Model = C > 400 Human Body Model = 3B > 8000 Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality should not be assumed, damage may occur and reliability may be affected. 1. The heat generated must be less than the thermal conductivity from Junction-to-Ambient: dP /dT < 1/R . D J JA THERMAL CHARACTERISTICS (Per Leg) Characteristic Symbol Value Unit Thermal Resistance, C/W Junction-to-Case R 1.5 JC Junction-to-Ambient (Note 2) R 50 JA 2. When mounted using minimum recommended pad size on FR4 board. ELECTRICAL CHARACTERISTICS (Per Diode) Symbol Characteristic Condition Min Typ Max Unit V Instantaneous Forward Voltage I = 15 Amp, T = 25C 0.62 V F F J (Note 3) I = 15 Amp, T = 125C 0.50 0.57 F J I = 30 Amp, T = 25C 0.82 F J I = 30 Amp, T = 125C 0.65 0.72 F J I Instantaneous Reverse Current Rated dc Voltage, T = 25C 0.2 mA R J (Note 3) Rated dc Voltage, T = 125C 9.0 25 J Product parametric performance is indicated in the Electrical Characteristics for the listed test conditions, unless otherwise noted. Product performance may not be indicated by the Electrical Characteristics if operated under different conditions. 3. Pulse Test: Pulse Width = 300 s, Duty Cycle 2.0%.