Signal Conditioning ICG-20330 High Performance 3-Axis OIS/EIS Optimized MEMS Gyro GENERAL DESCRIPTION APPLICATIONS The ICG-20330 is a 3-axis MotionTracking device that includes OIS (Optical Image Stabilization) in phone camera a 3-axis gyroscope in a small 3x3x0.75 mm (16-pin LGA) modules, DSLR, and DSC package. EIS (Electronic Image Stabilization) in DSC, and phone camera modules High performance specs o Gyroscope sensitivity error: 1% FEATURES o Gyroscope noise: 5 mdps/ Hz 1% Gyro initial sensitivity eliminates OIS dynamic calibration Includes 512-byte FIFO to reduce traffic on the serial bus Optimized OIS/EIS programmable gyro FSR of interface, and reduce power consumption by allowing 31.25dps, 62.5dps, 125ps and 250dps the system processor to burst read sensor data and then High Resolution at up to 1048 LSB/(/s) go into a low-power mode Low 5mdps/Hz Noise EIS FSYNC support User-programmable interrupts Wake-on-motion interrupt for low power operation ICG-20330 includes on-chip 16-bit ADCs, programmable of applications processor digital filters, an embedded temperature sensor, and 512-byte FIFO buffer enables the applications programmable interrupts. The device features an operating processor to read the data in bursts voltage range down to 1.71V. Communication ports include 2 On-Chip 16-bit ADCs and Programmable Filters I C and high speed SPI at 7MHz. Host interface: 7MHz SPI or 400kHz Fast Mode I2C Digital-output temperature sensor ORDERING INFORMATION VDD operating range of 1.71 to 3.45V MEMS structure hermetically sealed and bonded at AXES PART TEMP RANGE PACKAGE wafer level ICG-20330+ X,Y,Z -40C to +85C 16-Pin LGA RoHS and Green compliant Denotes RoHS and Green-Compliant Package TYPICAL OPERATING CIRCUIT BLOCK DIAGRAM ICG-20330 INT Self X Gyro ADC Interrupt test Status Register CS Self Y Gyro ADC Slave I2C and test SA0 / SDO SPI Serial FIFO Interface SCL / SPC SDA / SDI Self Z Gyro ADC test User & Config Registers FSYNC Temp Sensor ADC Sensor Registers Charge Bias & LDOs Pump VDD GND REGOUT InvenSense Inc. This document contains information on a pre-production Document Number: PB-ICG-20330-00 1745 Technology Drive, San Jose, CA 95110 U.S.A product. InvenSense Inc. reserves the right to Revision: 1.0 +1(408) 9887339 changespecifications and information herein without Revision Date: 11/30/2015 www.invensense.com notice. X-ON Electronics Largest Supplier of Electrical and Electronic Components Click to view similar products for Gyroscopes category: Click to view products by TDK InvenSense manufacturer: Other Similar products are found below : ADIS16334BMLZ ADIS16375BMLZ ADXRS620BBGZ-RL LY510ALHTR ICG-20330 L20G20ISTR ADIS16060BCCZ ISZ-2510 LPY530AL ADIS16135BMLZ ADIS16136AMLZ ADIS16260BCCZ ADIS16265BCCZ ADXRS290BCEZ ADXRS450BEYZ ADXRS450BRGZ ADXRS453BEYZ ADXRS620BBGZ ADXRS622BBGZ ADXRS623BBGZ ADXRS623BBGZ-RL ADXRS624BBGZ ADXRS624BBGZ-RL ADXRS642BBGZ ADXRS645HDYZ ADXRS646BBGZ ADXRS646TBGZ-EP ADXRS649BBGZ ADXRS652BBGZ ADXRS652BBGZ-RL ADXRS800WBRGZ SHUTTLE BOARD BMG250 SCC2130-D08-05 SCC2230-D08-05 SCC2230-E02-05 SCR1100-D02-05 SCR2100-D08-05 FXAS21002CQR1 A3G4250D I3G4250DTR L2G2ISTR L3GD20H LPR4150AL LPY510AL GYPRO2300 GYPRO2300LD GYPRO3300 IAM-20380