ECG001F InGaP HBT Gain Block Product Features Product Description Functional Diagram The ECG001F is a general-purpose buffer amplifier that DC 6 GHz GND offers high dynamic range in a low-cost surface-mount 1 6 RF OUT +12.5 dBm P1dB at 1 GHz package. At 1000 MHz, the ECG001F typically provides +25 dBm OIP3 at 1 GHz 22 dB of gain, +25 dBm Output IP3, and +12.5 dBm P1dB. GND 2 5 GND 22 dB Gain at 1 GHz The ECG001F consists of Darlington pair amplifiers using 3.4 dB Noise Figure the high reliability InGaP/GaAs HBT process technology RF IN 3 4 GND and only requires DC-blocking capacitors, a bias resistor, Available in lead-free / green and an inductive RF choke for operation. The device is SOT-363 package ideal for wireless applications and is available in a low- Internally matched to 50 Function Pin No. cost, surface-mountable lead-free/green/RoHS-compliant Input 3 SOT-363 package. All devices are 100% RF and DC Output/Bias 6 tested. Ground 1, 2, 4, 5 Applications The broadband MMIC amplifier can be directly applied to Mobile Infrastructure various current and next generation wireless technologies such as GPRS, GSM, CDMA, and W-CDMA. In addition, CATV / FTTX the ECG001F will work for other various applications W-LAN / ISM within the DC to 6 GHz frequency range such as CATV and mobile wireless. RFID WiMAX / WiBro (1) (1) Specifications Typical Performance Parameter Units Min Typ Max Parameter Units Typical Operational Bandwidth MHz DC 6000 Frequency MHz 500 900 1900 2140 S21 dB 22.6 22.4 20.9 20.6 Test Frequency MHz 1000 S11 dB -46 -42 -35 -29 Gain dB 22.2 S22 dB -29 -24 -18 -17 Output P1dB dBm +12.5 (2) Output P1dB dBm +12 +12.5 +12.5 +12.5 Output IP3 dBm +25 (2) Output IP3 dBm +23 +25 +26 +26 Test Frequency MHz 2000 Noise Figure dB 3.4 3.4 3.4 3.4 Gain dB 19.2 20.7 21.8 Input Return Loss dB 35 Output Return Loss dB 18 Output P1dB dBm +12.5 Noise Figure dB 3.4 Device Voltage V 3.0 3.4 3.8 Device Current mA 30 1. Test conditions unless otherwise noted: 25 C, Supply Voltage = +5 V, Rbias = 51 , 50 System. Absolute Maximum Rating Parameter Rating Ordering Information Operating Case Temperature -40 to +85 C Storage Temperature -55 to +150 C Part No. Description Device Current 150 mA InGaP HBT Gain Block ECG001F-G RF Input Power (continuous) +12 dBm (lead-free/green/RoHS-compliant SOT-363 package) Junction Temperature +250 C ECG001F-PCB 700 2400 MHz Fully Assembled Eval. Board Operation of this device above any of these parameters may cause permanent damage. Specifications and information are subject to change without notice WJ Communications, Inc Phone 1-800-WJ1-4401 FAX: 408-577-6621 e-mail: sales wj.com Web site: www.wj.com Page 1 of 5 April 2007 ECG001F InGaP HBT Gain Block Typical Device RF Performance Supply Bias = +5 V, R = 51 , I = 30 mA bias cc Frequency MHz 100 500 900 1900 2140 2400 3500 5800 S21 dB 22.8 22.6 22.4 20.9 20.6 20.2 18.6 15.5 S11 dB -48 -46 -42 -35 -29 -28 -22 -14 S22 dB -34 -29 -24 -18 -17 -16 -13 -8 Output P1dB dBm +11.6 +11.6 +12.6 +12.6 +12.6 +12.8 +12.2 +11 Output IP3 dBm +23.6 +23.5 +24.8 +26 +25.6 +25.4 +23 Noise Figure dB 3.4 3.4 3.4 3.4 3.4 3.4 1. Test conditions: T = 25 C, Supply Voltage = +5 V, Device Voltage = +3.4 V, Rbias = 51 , Icc = 30 mA typical, 50 System. 2. 3OIP measured with two tones at an output power of -1 dBm/tone separated by 1 MHz. The suppression on the largest IM3 product is used to calculate the 3OIP using a 2:1 rule. 3. Data is shown as device performance only. Actual implementation for the desired frequency band will be determined by external components shown in the application circuit. Icc vs. Vde Return Loss 0 100 Ga in (dB ) 24 DB( S(2,1) ) 80 22 -10 60 20 -20 18 40 -30 16 20 S11 S22 14 -40 0 0 1 2 3 4 5 6 Frequency (GH z) 0 1 2 3 4 5 6 3.2 3.3 3.4 3.5 3.6 Vde (V) Frequency (GHz) OIP3 vs. Frequency Noise Figure vs. Frequency P1dB vs. Frequency 18 28 5 16 4 26 14 3 24 12 2 10 22 1 8 +25C -40C +85C +25C -40C +85C 20 0 6 500 1000 1500 2000 2500 3000 500 1000 1500 2000 2500 3000 500 1000 1500 2000 2500 3000 Frequency (MHz) Frequency (MHz) Frequency (MHz) Specifications and information are subject to change without notice WJ Communications, Inc Phone 1-800-WJ1-4401 FAX: 408-577-6621 e-mail: sales wj.com Web site: www.wj.com Page 2 of 5 April 2007 Frequency OIP3 (dBm) NF (dB ) S11, S22 (dB) P1dB (dBm) Icc (mA)
