TGP2105 6-18 GHz 6-Bit Digital Phase Shifter (+Vc) Product Description Qorvos TGP2105 is a 6-bit, digital phase shifter fabricated on Qorvos high performance 0.15m GaAs pHEMT process. It operates over 6 to 18 GHz and provides 360 of phase coverage with a LSB of 5.625. It also achieves a low RMS phase error of 4 with 8 dB of insertion loss over all states. The TGP2105 uses positive switch logic, eliminating the need for a negative voltage rail. That, along with low insertion and a high degree of resolution makes the TGP2105 ideally suited for a variety of wideband phased array applications, including commercial and military radars, satellite-based communication systems and electronic warfare. Product Features Frequency Range: 6 to 18 GHz 6-Bit Digital Phase Shifter 360 Coverage, LSB = 5.625 RMS Phase Error: 4 RMS Amplitude Error: 0.45 dB Insertion Loss: <10 dB Return Loss: >12 dB Input P1dB: >25 dBm Input IP3: >41 dBm Control Voltage: 0/+5 V Block Diagram Chip Dimensions: 3.15 x 3.15 x 0.10 mm Applications Phased Array Antenna Systems Satellite Communication Systems Electronic Warfare Ordering Information Part No. Description 1096002 Waffle Pack, Qty 20 1101242 TGP2105 Evaluation Board - 1 of 10 - Data Sheet Rev. B. Oct 02, 2019 Subject to change without notice www.qorvo.com TGP2105 6-18 GHz 6-Bit Digital Phase Shifter (+Vc) Absolute Maximum Ratings Recommended Operating Conditions Parameter Value Parameter Value 0 0 0 0 0 Control Voltage (5 , 11 , 22 , 45 , 90 , Control and Reference Voltage 6 V 0/+5 V 0 180 , REF) Control Current -15 to +5 mA Operating Temperature Range -40 C to +85 C Power Dissipation 0.9 W Electrical specifications are measured at specified test Input Power, CW, 50 , 85C 30 dBm conditions. Specifications are not guaranteed overall operating conditions. Channel Temperature 200 C Mounting Temperature (30 Seconds) 320 C Storage Temperature -55 to 150 C Operation of this device outside the parameter ranges given above may cause permanent damage. These are stress ratings only, and functional operation of the device at these conditions is not implied. Extended application of Absolute Maximum Rating conditions may reduce device reliability. Bias and Truth Table Control voltage Logic 0 = VL, value between 0 to 0.2 V Logic 1 = VH, value between +3V to +5V 0 0 0 0 0 0 Phase Shift 5 11 22 45 90 180 REF 0 (Reference) 0 0 0 0 0 0 1 5 1 0 0 0 0 0 1 11 0 1 0 0 0 0 1 22 0 0 1 0 0 0 1 45 0 0 0 1 0 0 1 90 0 0 0 0 1 0 1 180 0 0 0 0 0 1 1 355 1 1 1 1 1 1 1 Electrical Specifications Test conditions unless otherwise noted: 25 C Data de-embedded to device reference planes at end of feeds, data include bond wire effects 0 0 0 0 0 0 Control Voltage (REF, 5 , 11 , 22 , 45 , 90 , 180 ) VL = 0 V, VH = +5 V See Bias Truth Table Parameter Min Typical Max Units Operational Frequency Range 6 18 GHz Insertion Loss 6 - 10 dB Input Return Loss >12 dB Output Return Loss >12 dB RMS Phase Error 4 deg RMS Amplitude Error 0.45 dB Input P1dB >25 dBm Input IP3, Tone spacing = 10 MHz, Pin/Tone = 15 dBm >41 dBm Insertion Loss Temperature Coefficient 0.008 dB/C - 2 of 10 - Data Sheet Rev. B. Oct 02, 2019 Subject to change without notice www.qorvo.com