4-CHANNEL BUTTON RADIO TRANSMITTER RNK-04 MANUAL INSTRUCTION ZAMEL Sp. z o.o. ul. Zielona 27, 43-200 Pszczyna, Poland tel. +48 (32) 210 46 65, fax +48 (32) 210 80 04 www.zamelcet.com, e-mail: marketing zamel.pl DESCRIPTION TECHNICAL DATA Button radio transmitter RNK-04 is a transmitting device of wireless EXTA FREE RNK-04 control system. It is used to realise following Input rated voltage: 3 V DC control functions: switching on / switching off, brightening / dimming, roller blinds rais- Battery type: CR2032 ing / lowering and time operation mode. Battery life: 3 5 years (depends on use) The transmitter can be mounted on any sur- Number of channels: 4 face (glass, wood, etc.) as it is quite small, not too heavy and it does not require external Transmission: radio 868,32 MHz power supply connection. Coding way: unidirectional Coding: addressing transmission Range: up to 250 m in the open area FEATURES Optic signalling of transmition/battery status: LED red diode 2-button, 4-channel radio transmitter, o Ambient temperature range: -10 +55 C remote control of EXTA FREE system re- Operating position: free ceivers, possibility of independent control of two Casing mounting: wall plugs, double-sided adhesive tape receivers, Casing protection degree: IP20 (EN 60529) wide range of operation (up to 250 m), battery powered, Protection level: III easy mounting and installation in any Pollution degree: 2 place, Dimensions: 90 x 80 x 11,5 mm sending information and battery status are optically signalled, Weight: 0,038 kg possibility of simultaneous switching on/ Reference standard: ETSI EN 300 220-1, switching off any number of EXTA FREE ETSI EN 300 220-2 system receivers. APPEARANCE Optic signalling of transmitters operation Push-buttons Base The symbol means selective collecting of electrical and electronic equipment. It is forbidden to put the used equipment together with other waste. VER. 003 20.05.2011FUNCTIONING, MOUNTING By pressing the button, the transmitter sends a signal with 868,32 MHz frequency which controls EXTA FREE receivers. Device pro- gramming procedure (adding a transmitter to a receivers memory) is described in particular EXTA FREE manual instructions. The device range (up to 250 m depending on a receiver) can be increased by means of a retransmitter or few RTN-01 retransmitters. The device can be mounted in any place by means of double-sided adhesive tape or wall plugs 5 x (3 x 30) mm. Mounting by means of wall plugs: 1. Remove push-buttons - to do it press a push-button on one side, and on the other side put a screwdriver into a slot and lift it up. 2. Find a place on the wall to mount the transmitter, make two holes corresponding mounting holes from the transmitters base. 3. Set wall plugs in the holes. 4. Fix the base by tightening the screws into wall plugs. 5. Place the push-buttons back. . 1 BATTERY CHANGE Battery discharge status is signalled by several LED red diode flashes during transmission time. 1. Remove push-buttons (Fig. 1). 2. By means of a screwdriver lever up the printed- circuit board releas ing the bottom latch (Fig. 2) and remove it from the base. 3. Remove the battery from the latch. (Fig. 3) 4. Mount a new battery. Watch battery polarisation marked on the latch. Wrong battery mounting may cause device damage. 5. Put the removed printed-circuit board back in the base. . 2 . 3 6. Place the push-buttons back. CAUTION: While changing the battery, it is suggested to press any of the buttons for about 5 seconds before putting it into a latch. Next press transmission button several times to check its operation. If the transmitter does not work properly repeat the battery change procedure. APPLICATION RNK-04, RWL-01 ( / ), RDP-01 ( / / ) SRP-02 (/ ). ZAMEL , . COOPERATION AND OPERATING RANGE Symbol ROP-01 ROP-02 ROB-01 SRP-02 SRP-03 RWG-01 RWL-01 ROM-01 ROM-10 RDP-01 RTN-01 RNK-02 180 m 200 m 200 m 200 m 200 m 250 m 180 m 250 m 250 m 180 m 250 m RNK-04 180 m 200 m 200 m 200 m 200 m 250 m 180 m 250 m 250 m 180 m 250 m CAUTION: The given range concerns open area - an ideal condition without any natural or artificial obstacles. If there are some obstacles between a transmitter and a receiver, it is advisable to decrease the range according to: wood and plaster: from 5 to 20 %, bricks: from 10 to 40 %, reinforced concrete: from 40 to 80 %, metal: from 90 to 100% , glass: from 10 to 20 %, Over- and underground medium and high electrical power lines, radio and television transmitters, GSM transmitters set close to a device system have also a negative influence on the range. WARRANTY CARD There is 24 months guarantee on the product 1. ZAMEL provides a two-year warranty for its products. 2. The ZAMEL warranty does not cover: a) mechanical defects resulting from transport, loading / unloading or other circumstances b) defects resulting from incorrect installation or operation of ZAMEL products c) defects resulting from any changes made by CUS- TOMERS or third parties, to products sold or equipment necessary for the correct operation of products sold d) defects resulting from force majeure or other aleatory events for which ZAMEL is not liable e) power supply (batteries) to be equipped with a device in the moment of sale (if they appear) 3. All complaints in relation to the warranty must be provided by the CUSTOMER in writing to the retailer after discovering a defect. 4. ZAMEL will review complaints in accordance with existing regulations. 5. The way a complaint is settled, e.g. replacement of the product, repair or refund, is left to the discretion of ZAMEL. 6. Guarantee does not exclude, does not limit, nor does it suspend the rights of the PURCHASER resulting from the discrepancy between the goods and the contract. Salesman stamp and signature, date of sale VER. 003 20.05.2011