RADIO FOOT TRANSMITTER RNL-01 MANUAL INSTRUCTION ZAMEL Sp. z o.o. ul. Zielona 27, 43-200 Pszczyna, Poland tel. +48 (32) 210 46 65, fax +48 (32) 210 80 04 www.zamelcet.com, e-mail: marketing zamel.pl TECHNICAL DATA DESCRIPTION Radio foot transmitter RNL-01 is RNL-01 a device used to control radio receivers of EXTA FREE system. It can be used Input rated voltage: 3 V DC in wireless control of e.g., garage gate. Battery type: CR2032 The device is battery powered (one battery). Battery life: 3 5 years (depends on use) Number of channels: 1 Transmission: radio 868,32 MHz Coding way: unidirectional FEATURES Coding: addressing transmission 1-channel radio transmitter, Range: up to 200 m in the open area remote control of EXTA FREE system Optic signalling of transmition/battery discharge: LED red diode receivers, o Ambient temperature range: -10 +55 C wide range of operation (up to 200 m), Operating position: free mounting and additional installatio n is not required, Casing protection degree: IP20 (EN 60529) battery powered, Protection level: III sending information and battery status Pollution degree: 2 are optically signalled, Dimensions: 75 x 40 mm possibility of simultaneous switching on/switching off any number of EXTA Weight: 0,06 kg FREE system receivers, Reference standard: ETSI EN 300 220-1 ETSI EN 300 220-3 possibility of increasing operation range by means of RTN-01 retransmitter. APPEARANCE Foot push-button Optic signalling of transmitters operation The symbol means selective collecting of electrical and electronic equipment. It is forbidden to put the used equipment together with other waste. VER. 004 11.07.2011FUNCTIONING, MOUNTING By pressing the button, the transmitter sends a signal with 868,32 MHz frequency which controls EXTA FREE receivers. Device programming procedure (adding a transmitter to a receivers memory) is described in particular EXTA FREE manual instructions. The device range (up to 250 m depending on a receiver) can be increased by means of a retransmitter or few RTN-01 retransmitters. BATTERY CHANGE Battery discharge status is signalled by several LED red diode flashes during transmission time. 1. Remove the upper cover of the transmitter - to do it lever up four latches at the bottom of the push-button removing the cover at the same time. 2. By means of a screwdriver remove the battery from the latch. 3. Mount a new battery. Watch battery polarisation marked on the latch. Wrong battery mounting may cause device damage. 4. Put the spring on the push-button (it is important that the smaller spring diameter secured with insulation leans against the push-button). 5. Put back the upper cover by placing the latches of the cover straight into their base and snap it. CAUTION: While changing the battery, it is suggested to press any of the buttons for about 5 seconds before putting it into a latch. Next press transmission button several times to check its operation. If the transmitter does not work properly repeat the battery change procedure. APPLICATION Radio foot transmitter RNL-01 controls operation of RWL-01 radio lighting switch (switch on / switch off) or RDP-01 radio dimmer (switch on / switch off, light brightening / dimming). The receivers can be controlled by 4-channel button radio transmitter RNK-04. The RNL- 02 transmitter does not require additional installation, external power supply connection The ZAMEL company devices and mounting. which are characterised with this sign can cooperate with each other. COOPERATION AND OPERATING RANGE Symbol ROP-01 ROP-02 ROB-01 SRP-02 SRP-03 RWG-01 RWL-01 ROM-01 ROM-10 RDP-01 RTN-01 RNK-02 180 m 200 m 200 m 200 m 200 m 250 m 180 m 250 m 250 m 180 m 250 m RNK-04 180 m 200 m 200 m 200 m 200 m 250 m 180 m 250 m 250 m 180 m 250 m P-256/8 230 m 250 m 250 m 250 m 250 m 300 m 200 m 300 m 300 m 230 m 300 m P-257/4 (2) 180 m 200 m 200 m 200 m 200 m 250 m 180 m 250 m 250 m 180 m 250 m RNM-10 230 m 250 m 250 m 250 m 250 m 300 m 200 m 300 m 300 m 230 m 300 m RNP-01 160 m 180 m 180 m 180 m 180 m 200 m 160 m 200 m 200 m 160 m 200 m RNP-02 160 m 180 m 180 m 180 m 180 m 200 m 160 m 200 m 200 m 160 m 200 m RNL-01 160 m 180 m 180 m lack* lack* 200 m 160 m 200 m 200 m 160 m 200 m RTN-01 200 m 200 m 200 m 200 m 200 m 250 m 200 m 250 m 250 m 200 m 250 m RCR-01 160 m 180 m 180 m lack* lack* 200 m 160 m 200 m 200 m 160 m 200 m RTI-01 160 m 180 m 180 m 180 m 180 m 200 m 160 m 200 m 200 m 160 m 200 m RXM-01 230 m 250 m 250 m 250 m 250 m 300 m 200 m 300 m 300 m 230 m 300 m * - 1-channel transmitters do not cooperate with roller blind controllers. CAUTION: The given range concerns open area - an ideal condition without any natural or artificial obstacles. If there are some obstacles between a transmitter and a receiver, it is advisable to decrease the range according to: wood and plaster: from 5 to 20 %, bricks: from 10 to 40 %, reinforced concrete: from 40 to 80 %, metal: from 90 to 100% , glass: from 10 to 20 %. Over- and underground medium and high electrical power lines, radio and television transmitters, GSM transmitters set close to a device system have also a negative influence on the range. WARRANTY CARD There is 24 months guarantee on the product 1. ZAMEL provides a two-year warranty for its products. 2. The ZAMEL warranty does not cover: a) mechanical defects resulting from transport, loading / unloading or other circumstances b) defects resulting from incorrect installation or operation of ZAMEL products c) defects resulting from any changes made by CUS- TOMERS or third parties, to products sold or equipment necessary for the correct operation of products sold d) defects resulting from force majeure or other aleatory events for which ZAMEL is not liable e) power supply (batteries) to be equipped with a device in the moment of sale (if they appear) 3. All complaints in relation to the warranty must be provided by the CUSTOMER in writing to the retailer after discovering a defect. 4. ZAMEL will review complaints in accordance with existing regulations. 5. The way a complaint is settled, e.g. replacement of the product, repair or refund, is left to the discretion of ZAMEL. 6. Guarantee does not exclude, does not limit, nor does it suspend the rights of the PURCHASER resulting from the discrepancy between the goods and the contract. Salesman stamp and signature, date of sale