TAT7460B1A Qorvo

TAT7460B1A 75 5V 50-2600 MHz RF Amplifier Applications Distribution Amplifiers Multi-Dwelling Units Drop Amplifiers Single-ended Gain Block SOT-89 Package FTTH Receivers Product Features Functional Block Diagram 502600MHz Bandwidth GND Low Noise Figure: 3.0dB up to 1600MHz Extremely Flat Gain Response Low Power Consumption: 100mA with 5V SOT-89 package 1 2 3 General Description RF IN GND RF OUT/V DD The TAT7460B1A is a 75Ohm RF Amplifier designed for use up to 2600MHz, addressing the CATV and Satellite Pin Configuration bands in a single part. The TAT7460B1A is fabricated using six inch GaAs pHEMT technology to optimize Pin No. Label performance and cost. 1 RF IN 2 GND 3 RF OUT/V DD Backside Tab GND Ordering Information Part No. Description TAT7460B1A 75 pHEMT Amplifier TAT7460B1A-EVB 502600 MHz Evaluation Board Standard T/R size = 1000 pieces on a 7 reel. Datasheet: Rev A 2/14/14 - 1 of 7 - Disclaimer: Subject to change without notice 2014 TriQuint www.triquint.com TAT7460B1A TAT7460B1A 75 5V 50-2600 MHz RF Amplifier Absolute Maximum Ratings Recommended Operating Conditions Parameter Rating Parameter Min Typ Max Units Storage Temperature 65 to 150C Device Voltage (V ) 4.5 5.0 6.5 V DD Device Voltage (V ) +10V Device Voltage (I ) 100 120 mA DD DD Operation of this device outside the parameter ranges Case Temperature 40 +85 C 6 given above may cause permanent damage. Tj for >10 hours MTTF +150 C Electrical specifications are measured at specified test conditions. Specifications are not guaranteed over all recommended operating conditions. Electrical Specifications Test conditions unless otherwise noted: V =+5V, Temp= +35C, Freq.=502600 MHz DD Parameter Conditions Min Typ Max Units Operational Frequency Range 50 2600 MHz Gain 17 dB Gain Flatness Deviation from sloped response +/- 0.35 dB Input Return Loss 14 dB Output Return Loss 14 dB CSO -60 dBc 30 dBmV/channel at output CTB -73 dBc 80 channels flat XMOD -70 dBc Output IP2 +46 +52 dBm Pout = +5dBm/tone f1=225MHz, f2=325MHz Output IP3 +31 +38 dBm Output P1dB +20 dBm Noise Figure 501600MHz 3.0 dB Device Current (I ) 70 90 120 mA DD Thermal Resistance, Junction to case 36 C/W jc Datasheet: Rev A 2/14/14 - 2 of 7 - Disclaimer: Subject to change without notice 2014 TriQuint www.triquint.com